So...I think some one backed into my passenger side bumper, either that or I met with some huge rocks following trucks down deerfoot.

where the bumper meets the fender is off by a little, the only indication it's been hit are two paint chips, no cracks or anything. I was able to get the fender lining off and re-align that part of the bumper as best as I could, it looks 100x better than it did, but it's still off a little, and I believe I need to actually need to remove the bottom clips to get a little more give, but I need a floor jack and jackstands to access the bottom screws and be able to put them back in.

I'm in the NE of calgary, but am willing to travel, the bumper DOES need to be repainted due to an unfortunate accident with a polisher and pads that were just slightly too small...but I don't want to repaint it just yet, so I want to re-align the bumper my self.

Will bring beer!

Thanks

=)

 

invest in a set, u'll need it for many other things, just get a 2 ton set.

 

I have a set like 1400km away...so I'm not buying another one =/

 

Daemos ... I was actually thinking of buying a set of jackstands the other day so I can change my transmission fluid but I got side tracked (money is going towards the Cobb AP) ... so sorry not just yet

You can try u-wrench .. they rent out space in their garage and let you use their equipment OR if you want, they can do the work for you
www.u-wrench.ca