i have my CEL on, scanned it and this is what i got. does anybody know what exactly this means, how to fix/get rid of it and the reason why this happened. thanks for all the help! =)

 

http://www.williamperrine.com/RX_8_M...ineControl.pdf

Technical manual... read all about it.

 

One step easier for you.... starting at page 158 and go from there. Good luck.

 

DTC P0327 KS circuit low input

DETECTION CONDITION

• The PCM monitors the input voltage from the KS when the engine is running. If the input voltage is less than 1.2 V, the PCM determines that the KS circuit input voltage is low.

Diagnostic support note
• This is a continuous monitor (CCM).
• The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
• PENDING CODE is available if the PCM detects the above malfunction condition.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.

POSSIBLE CAUSE

• KS malfunction
• Connector or terminal malfunction
• Open circuit in wiring harness between KS terminal A and PCM terminal 1T
• Short to GND in wiring harness between KS terminal A and PCM terminal 1T
• Open circuit in wiring harness between KS terminal B and PCM terminal 1F
• Short to GND in wiring harness between KS terminal B and PCM terminal 1F
• PCM malfunction

 

thanks for the help guys, ill probably try to fix it during the weekend, its not like its going to hurt anything right =S

 

and thanks for the link andrew, will probably print all of it for future problems =)

 

wow O_O, i checked my knock sensor today, well guess what i found, an oil filter wrench on top of the sensor, i took it out and the CEL disappeared =/. i did my oil change two weeks ago at airport mazda, well i guess ill be stopping over at the dealership on monday to drop their wrench =/

 

Don't forget to give them ****... that's unprofessional.