WANTED Passenger side tail light assembly
#1
WANTED Passenger side tail light assembly and driverside window motor
Last edited by dirtyd; 08-05-2009 at 08:33 PM.
#2
I need one too. Why do you need one? If your getting moisture build up in it you can buy a gasket to fix that at a Mazda dealer. There not cheap, about 30 bucks a side.
I need one because I was too cheap to buy the gasket so I punched a hole in the bottom of the light to drain it. Believe it or not this trick worked pretty good. However...I broke a retainer clip taking it out and putting it back in so many times, lol...good ol silicone should hold it for a bit.
I need one because I was too cheap to buy the gasket so I punched a hole in the bottom of the light to drain it. Believe it or not this trick worked pretty good. However...I broke a retainer clip taking it out and putting it back in so many times, lol...good ol silicone should hold it for a bit.
#3
i dried the moisture with a hair dryer for the second time and re-seal it with more silicone, after I re-installed it i noticed that i put too much heat to it and now there is alot of cracks all over the lens
Thread
Thread Starter
Forum
Replies
Last Post
Crazy.8
Series I Interior, Audio, and Electronics
3
04-18-2017 03:17 PM
SayDfuse
Series I Exterior Appearance and Body Kits
3
08-03-2015 10:41 PM