Official SARX Lounge
#5305
what was I thinking
iTrader: (8)
I have had this low speed "clunk" noise since the week after I did suspension and swaybar. All the research says loose links cause this noise but I have tightened them several times. I preloaded the suspension twice and check all the nuts/bolts. One time the links were in fact loose...just FYI....the AP link have extremely cheap lock nuts (this will be remedied soon). Is there any reason I would not be able to drive around for a day with the bar disconnected (nothing overzealous obviously) to see if the noise goes away?
I wouldn't describe the noise as a "dangerous sounding noise" but it sure is hell is annoying!
I wouldn't describe the noise as a "dangerous sounding noise" but it sure is hell is annoying!
#5308
what was I thinking
iTrader: (8)
My goal is to take it off and drive around the neighborhood where all the kids are playing in the street...jk.....dont need to go fast but I wanted to be prepared in the event I didnt get everything back together tonight.
#5312
Administrator
iTrader: (7)
#5314
SARX Legend
iTrader: (46)
You had some? My front right was seized, I got it un seized before i garaged the car but I figure while the car is up and apart I might as well address it and since these are basically new they should be great..
#5315
Administrator
iTrader: (7)
#5318
WENTGERMAN
iTrader: (6)
The only shitty part is the amount of money I need to spend on the whole endeavor. at this point I could have gotten the expensive bushings with the sleeves.
So lesson learned buy the drop engineering/MS/Speedsource upper/lower control arm kit.
#5322
what was I thinking
iTrader: (8)
Nah I was just joking around... I get over **** pretty quickly, also i think its gonna be cool melting rubber.
The only shitty part is the amount of money I need to spend on the whole endeavor. at this point I could have gotten the expensive bushings with the sleeves.
So lesson learned buy the drop engineering/MS/Speedsource upper/lower control arm kit.
The only shitty part is the amount of money I need to spend on the whole endeavor. at this point I could have gotten the expensive bushings with the sleeves.
So lesson learned buy the drop engineering/MS/Speedsource upper/lower control arm kit.