Official SARX Lounge
#7209
what was I thinking
iTrader: (8)
next build I am game or if I come into a bunch of money
anyone wanna buy
industrial coffee roaster
9.9hp boat motor (needs a little love)
tons of RC **** (all kinds....all gas)
(all my OEM parts...hmmm maybe I should make a FS thead)
5hp garden tiller (needs a little love)
you could buy one of these (my Dad's hobbu is engeering something to the extreme) 7 sold so far
http://www.ebay.com/itm/Universal-Pa...item4602bba884
anyone wanna buy
industrial coffee roaster
9.9hp boat motor (needs a little love)
tons of RC **** (all kinds....all gas)
(all my OEM parts...hmmm maybe I should make a FS thead)
5hp garden tiller (needs a little love)
you could buy one of these (my Dad's hobbu is engeering something to the extreme) 7 sold so far
http://www.ebay.com/itm/Universal-Pa...item4602bba884
#7213
what was I thinking
iTrader: (8)
btw...check out my dad's and ly new project. first the introduction.....if you are not familiar with anvil launching the check out the youtube vid below (hope this works never embeded a vid before)
http://youtu.be/IhQ4dE_RGnQ
if you were not familiar you now know how exciting it can be (btw I have no relation to the man in the vid)
now check out what we designed with some 80lb steel bar ends that have been at our farm since I was a kid
![Name: IMG_0150.jpg
Views: 12
Size: 164.9 KB](https://www.rx8club.com/attachments/gulf-rx-8-forum-32/234563d1501238406-official-sarx-lounge-img_0150.jpg)
if you look it over you can figure it out but basically its 2 80lb chunks of steel with a tube....this allows you to harness more of the forces vs the standard anvil in the vid above.
next trip to the farm I promise to share vids
http://youtu.be/IhQ4dE_RGnQ
if you were not familiar you now know how exciting it can be (btw I have no relation to the man in the vid)
now check out what we designed with some 80lb steel bar ends that have been at our farm since I was a kid
![Name: IMG_0150.jpg
Views: 12
Size: 164.9 KB](https://www.rx8club.com/attachments/gulf-rx-8-forum-32/234563d1501238406-official-sarx-lounge-img_0150.jpg)
if you look it over you can figure it out but basically its 2 80lb chunks of steel with a tube....this allows you to harness more of the forces vs the standard anvil in the vid above.
next trip to the farm I promise to share vids
#7219
Registered
iTrader: (6)
Join Date: Sep 2011
Location: San antonio tx. SARX
Posts: 1,001
Likes: 0
Received 0 Likes
on
0 Posts
i took it to a body shop by topperwein st i went to the bs you recommended and they asked for 750 for fender and hood and at other place they charged me 800 for 2 fenders hood eye lids and they said they would polish the whole car.lets see how well they do
#7223
Pew Pew Pew
iTrader: (10)
My friend was pretty hardcore into detailing for a while, so I just let him do it. It is almost fail-proof with the right equipment so I hear. I did have part of my door buffed too much though. It's lighter than the rest of the door now. Wade's Auto Body in Waco bastards.