houstonrx8er

iTrader: (8)

it looks like you get you run of the mill on selection....as think or as thin as you want

BTW check out my build thread.

shadycrew31

iTrader: (6)

Woot!

So why in the **** are you getting the same bearing wear?

houstonrx8er

iTrader: (8)

not sure...more measurements to come

shadycrew31

iTrader: (6)

Get it right Get it tight.

houstonrx8er

iTrader: (8)

can we change it to "get it right....or take your engine out unnecessarily?"

9krpmrx8

iTrader: (46)

houstonrx8er

iTrader: (8)

she looks kind of strung out ...nice ***** though

9krpmrx8

iTrader: (46)

Mind the gap.

houstonrx8er

iTrader: (8)

that will work as a theme

shadycrew31

iTrader: (6)

I will make a baby in her and fix that whole cracked out look.

9krpmrx8

iTrader: (46)

You will screw that gap up man, don't do it.

shadycrew31

iTrader: (6)

She can be my workout buddy, resulting in the gap returning to its original state.

9krpmrx8

iTrader: (46)

Attention Hoss-05, Shadycrew31, and hector castillo:

I would like to header wrap my entire exhaust from the DP all the way to the rear muffler section. Can you guys please do this for me? It looks like a pain in the *** and I don't really want to mess with it so if you guys could do it for me I would appreciate it.

shadycrew31

iTrader: (6)

no problem I'll hook you up bro.

you buy the wrap I'll do the work...


you may or may not have some bolts removed, once removed I may or may not wrap over those sections causing multiple exhaust leaks... Resulting in the greatest troll of the century.

houstonrx8er

iTrader: (8)

done....check it!

Hector Castillo

iTrader: (6)

for sure bro

houstonrx8er

iTrader: (8)

whos is this?

9krpmrx8

iTrader: (46)

That has to be Shady's.

houstonrx8er

iTrader: (8)

I wasnt sure if that was "metro" enough

shadycrew31

iTrader: (6)

Dam I knew I left that there!!! I've been looking for that forever.

houstonrx8er

iTrader: (8)

cup/bottle located....give it to you this weekend

shadycrew31

iTrader: (6)

Baller... Thanks braaaa.

houstonrx8er

iTrader: (8)

OD's comment in my thread is kind of interesting...not that I think the "lobes" are twisted but there are only a few things that could cause the bore to be out of allignement/internal tension.....none of which I think I can measure

houstonrx8er

iTrader: (8)

I am going to get the PDF of the "engine detail" & "engine workshop" manuals printed at kinkos....does anyone want a copy....$36 it looks like.

9krpmrx8

iTrader: (46)

Will the pages be double sided?