trans trouble
#1
Registered
Thread Starter
trans trouble
let me start by yes i know this is not where its it should go but i need help
i just instaled a xtd stage 4 six puck ceramic clutch and presure plate and now it will not go into gear
yes i checked the pedle bracket not broke. the yoke was fine to when put back in.
all of this started about a year ago when slave cilender quit clutch never was right after that. what was hapening was at 7k rpm would not shift 3 or so months later down to 6k and would not shift with out grinding it got to about 4k and income tax came in this year and time to change now wont shift at all
after install of new clutch pedle went right to the floor on its own had to pull up by hand bled lines check for cracked mounting bracket
only thing that makes seens is master cilender going to change to marrow it was not changed when slave cilender was and is last thing i can think of plezz help
i just instaled a xtd stage 4 six puck ceramic clutch and presure plate and now it will not go into gear
yes i checked the pedle bracket not broke. the yoke was fine to when put back in.
all of this started about a year ago when slave cilender quit clutch never was right after that. what was hapening was at 7k rpm would not shift 3 or so months later down to 6k and would not shift with out grinding it got to about 4k and income tax came in this year and time to change now wont shift at all
after install of new clutch pedle went right to the floor on its own had to pull up by hand bled lines check for cracked mounting bracket
only thing that makes seens is master cilender going to change to marrow it was not changed when slave cilender was and is last thing i can think of plezz help
#2
Registered
Thread Starter
even though i got no input from eney one problem fixed car runs grate love the feel of the xtd stage 4 six puck ceramic clutch will see how long it lasts
#3
Registered
Thread Starter
We'll it's been a good bit of time now and no trouble out of the clutch but hammering the trans has done a bit of damage sincro's seem to be going 1st gear almost will not go in till at a dead stop but all parts added to the car are doing grate engine is at 136k and strong
Thread
Thread Starter
Forum
Replies
Last Post
TotalAutoPerformance
Vendor Classifieds
12
10-17-2018 09:00 AM