We will fit in dyno only runs as appropriate throughout the day, but priority is going to the 6 tuning slots.

Translation: there's no guarrantee there will be ANY dyno only runs.

 

shell did you get the upgraded fuel pump yet?

 

We ruled out fuel pressure as an issue. Primary and secondary injectors have been replaced. We're still at a loss as to what else the problem could be.... Will cry like a baby if my AFRs spike again at 7k.

Fortunately Dave will be there if it happens and we can shake it up.

 

lol
no problem I thought it was sunday anyway..... I might still try to stop by to BS and hear some rotarys on the Dyno.... they Sound so sweet

 

wanna caravan D?

 

I'll keep u posted ray....
Me and the lady should be picking up the new beater on sat

 

Checked in my flight. I hit Allentown around 10:00pm tomorrow.
See y'all Saturday morning!

 

sadly things are crazy at work, just found out 30 min ago that i have to work 10-12 hour days sat and sun. it sux cause i really wanted to go but time and a half and double time is nice. i hope someone can post some pics. have fun and good luck guys

 

Shell if you wanna convoy up just shoot me a text.

 

Oh btw I believe there is a update for the AP. Not sure if it's needed for MM but I put it on just incase.

 

Can someone shoot the address of the shop to my phone e-mail? palm @ mazdamaniac.com
Thanks!

 

good luck Shell, I'm pulling for everything to go smooth tomorrow and hopefully your car plays nice while Jeff is tuning it.

any chance we'll get a live feed of the event?

 

^sent

 

I have your live feed right here Jorge


























jk, I will be there for a bit tomorrow. I will ask around.

 

jeff: 898 Old Rt. 22
Lenhartsville, PA 19534
Phone (610) 756-3000

 

Is this the weekend we finally see some decent numbers from a turbo AT ?

 

I already took care of it Jedi, geeshh.. Trying to one up me all the time















jk I'm not worthy

 

no pressure Shell Dude!
Remember: when in doubt, just keep turning up the boost. somewhere around 14 psi should do the trick. *
I assume zero liability / responsibility for what may occur should anyone choose to follow the advice above. Proceed at your own risk...

 

We are hoping. Both Shelldude and Markryan upgraded a lot of parts in order to receive their correct numbers.

Also there is a fresh MM upgrade turbo install on a MT. I am very anxious to see what that does

 

Jorge if there is a live feed and I say heeyyy Jedii its Adam and sephy and you say who the Fawk is adam. Ima go cut my wrists..

 

LMAO!!!!

sorry bro, it was a long day and I still feel bad about that.
It was kinnda funny though.
sorta?

 

it was hilarious though.

Everyone at the shop was like "Haha burnnnn.."

 

One of secondaries were pretty fuggly... Both of the primaries looked like crap so fingers crossed.

Jeff I sent you address too so I'm sure you're good to go at this point.

Likely won't have a live feed. Internet connection at the shop is 3G.

 

I am bringing my HD camcorder and will record the dyno runs (for those who wish to be recorded). After the event I can upload them to youtube.

 

Dave just called me, my 8 will be done around 10am tomorrow. they have to finish the intake install.