any procedures fail, electrical problem?
#1
any procedures fail, electrical problem?
Hello dear rx 8 club members ![Wink](https://www.rx8club.com/images/smilies/wink.gif)
In my rx 8 from 2004 HP I have problem with procedures especially with two ones:
key on acc positon and 20 times depress brake pedal- oil pressure gauge not jumping but it should,
second
problem with keyless programming procedure- tired it so many many times and nothing--- pilot visteon 41844 is working, checked by specialists...
any ideas what to do? Any fuses? I checked transparent ones and all was god
![Wink](https://www.rx8club.com/images/smilies/wink.gif)
In my rx 8 from 2004 HP I have problem with procedures especially with two ones:
key on acc positon and 20 times depress brake pedal- oil pressure gauge not jumping but it should,
second
problem with keyless programming procedure- tired it so many many times and nothing--- pilot visteon 41844 is working, checked by specialists...
any ideas what to do? Any fuses? I checked transparent ones and all was god
![Frown](https://www.rx8club.com/images/smilies/frown.gif)
#2
Modulated Moderator
iTrader: (3)
Don't count the pedal presses...just keep pressing it until it sweeps.
If that still doesn't work you could have a really old PCM version. The original one didn't do this. If that is the case you should get the PCM updated...
The keyless programming can be a bit picky. I have had issues with it in the past. Sometimes you have to do it a few times before it works
If that still doesn't work you could have a really old PCM version. The original one didn't do this. If that is the case you should get the PCM updated...
The keyless programming can be a bit picky. I have had issues with it in the past. Sometimes you have to do it a few times before it works
#3
i tried keyless programming around so many many many times:P and nothing, with break pedal also, push it to the limit, so i contacted my local Mazda service and they will try to check whats wrong with keyless system and also with PCM
#4
Registered
viola. same as me. haha. but it turned out to be engine fuse 15a. immobilizer doesnt really mean that it's the key problem. most of the time is just a fuse problem. check all fuse again and again.
#5
Registered
and mine also doesnt work do anything no matter how many times i push the brakes. well, it's a 2003 and mazda dealers here have no PCM recall/update. so.. yeap
Thread
Thread Starter
Forum
Replies
Last Post