Front e-shaft pulley key won't go back in
#1
Registered
Thread Starter
Join Date: Jun 2024
Location: Detroit
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Eccentric shaft slipped while replacing oil seal
I was using a handy guide on this forum to replace the e-shaft seal (damaged by an exploding serpinetine belt), and got to the point where I was putting everything back on, but this rotten key won't go back in, I've tried rotating it a little to see if it would help, but to no avail.
I'm guessing I have to take the front cover off.
-Clutch has been depressed the entire time
-braced the fly wheel
EDIT:
I just put the pulley back on to confirm a hunch.
The key is where it is supposed to be, shaft is not.
now what
I'm guessing I have to take the front cover off.
-Clutch has been depressed the entire time
-braced the fly wheel
EDIT:
I just put the pulley back on to confirm a hunch.
The key is where it is supposed to be, shaft is not.
now what
Last edited by Thruxtonup; 06-22-2024 at 04:36 PM. Reason: Change of conditions
#3
Registered
Thread Starter
Join Date: Jun 2024
Location: Detroit
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Digitz0070
Series I Trouble Shooting
4
10-01-2019 10:33 AM