I need help with my rx8!!!!
#1
New Member
Thread Starter
Join Date: Mar 2015
Location: california
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
I need help with my rx8!!!!
Hi i need some help with my rx8 2004 i open to any ideas, the problem is that i start the car it run normally but when is hot and i turn off the engine, if i try to turn it on again it doesn't start i have to wait like 20 to 30 min and then it start, i have the code p0335 i replaced the eccentric shaft position sensor but the car still doing the same any ideas also i rebuild the engine
#4
Registered
iTrader: (2)
Join Date: Oct 2007
Location: Pacific Northwest
Posts: 16,684
Likes: 0
Received 253 Likes
on
110 Posts
How did you test the compression?
You have a completely brand new engine? every single part of the engine was replaced with brand new?
I'm not trying to be beligerant, but you have the symptoms of compression and botching a rebuild is a lot easier than most think.
You have a completely brand new engine? every single part of the engine was replaced with brand new?
I'm not trying to be beligerant, but you have the symptoms of compression and botching a rebuild is a lot easier than most think.
#5
New Member
Thread Starter
Join Date: Mar 2015
Location: california
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
i had a bad connection with the injectors the first time but i fixed and now is running good i only have this problem, i bought special tool for the compression, i'm a professional mechanic but this is the first time that i rebuild a engine like this i did everything manual said
#8
You gonna eat that?
iTrader: (1)
You should probably get the compression checked at a dealer.
Thread
Thread Starter
Forum
Replies
Last Post