Idling problems
#1
Idling problems
When I push in the clutch it idles fine when I release it and wants to idle up and down but it doesn't go over two grand when I unplug the air sensor on the air intake it stops new to this car and need some help thanks
#3
the AC has been deleted it has a brand new clutch master cylinder and the clutch sensor has been bypassed not 100% sure what the condition of the clutch plate is it has brand new ignition coils and wires and plugs and a brand new air sensor on a OBD2 when I release the clutch it puts a load on the engine it has a couple other standard deletes to tomorrow I'm going to change the transmission fluid and do a compression check it doesn't have any hot or cold starting problems or stalling so I don't think it's the Apex seals the weird idle goes away to sometimes it's not even there
The following users liked this post:
Eddiegordozen (07-15-2020)
#5
Registered
I have the idle surge when I release the clutch. So I replaced the switch on the top of the clutch pedal that get depressed when you release the clutch. Still does it. So I un clipped the switch, left it plugged in and tucked it away to the side. Doesn't do it now😏. I can't figure it out. Everything is new. Both clutch cylinders the throwout bearing, clutch and pressure plate. Also the reverse and neutral switches are replaced.
Thread
Thread Starter
Forum
Replies
Last Post