JDM 5 Speed MT Swap
#1
New Member
Thread Starter
JDM 5 Speed MT Swap
So I am doing a REW swap /w a JDM 5speed MT from the JDM RX8. I'm assuming the 5speed trans harness and the 6-speed will not have the same connectors and I will need a 5-speed trans harness to splice with my existing harness? Is that correct or can I use my existing harness?
Last edited by FenriRx8; 10-04-2022 at 02:45 PM. Reason: Clarification
#2
Modulated Moderator
iTrader: (3)
So I am doing a REW swap /w a JDM 5speed MT from the JDM RX8. I'm assuming the 5speed trans harness and the 6-speed will not have the same connectors and I will need a 5-speed trans harness to splice with my existing harness? Is that correct or can I use my existing harness?
The following users liked this post:
FenriRx8 (10-04-2022)
#3
No respecter of malarkey
iTrader: (25)
that may depend on which MY, because the S2 trans has different plugs than the S1 and I’m pretty sure they still sold the 5 spd during the S2 period
otherwise S1 should mate with S1 if they’re both 2004 - 2008
they are all either 1 or 2 wire plugs though, so easy to convert to something universal like Deutsch etc. if it comes down to it.
.
otherwise S1 should mate with S1 if they’re both 2004 - 2008
they are all either 1 or 2 wire plugs though, so easy to convert to something universal like Deutsch etc. if it comes down to it.
.
Thread
Thread Starter
Forum
Replies
Last Post