Just bought car......
#27
rotary diagnostics , its not a standalone, which makes it a bit less convenient than Travis' testers, but it gets the job done. hook it up the pc and it shows you in the form of a graph with readable psi with some pretty good accuracy. only downside is you have to calculate your rpm of your starter with real math (yuck) . Super easy to see if you have catastrophic failures though. just check the peaks of the graph , if two are low and one is high, generally a pretty obvious failure , and thats without checking any of the actual numbers.
#28
Got it running! Followed deflood procedures! It did have a little idle hunt at first but that seemed to stabilize. Coolant warning light flashed on and of a couple times so drove home and parked it. Time to do coolant flush before I drive again. Which I hope i can do next week.
Thank you everyone from the bottom of my heart. Y'all are awesome!
Thank you everyone from the bottom of my heart. Y'all are awesome!
TLDR: check your coolant level, if its not low, dont waste your money , its the sensor, just unplug it and periodically check your fluid levels.
#32
You gonna eat that?
iTrader: (1)
it might be worth noting that the coolant sensor is an extremely common thing on these vehicles to have fail. if your coolant level is at the appropriate level (which can easily be visualized in the coolant tank) than my suggestion to you would be simply to unplug your coolant sensor (attached to the bottle) I personally have had the same thing happen with mine and have seen many 8's with the same issue. this is easily found if you search the issue on these forums if you wish to see what i'm speaking of. to my understanding the sensor just more or less corrodes and stops being accurate after years of being covered in coolant. only fix is to replace the whole coolant tank, as the sensor in built into the tank. instead of spending the money , most of us do what i mentioned and just unplug the sensor, and the paranoid ones check their coolant level as you add your oil every other week or so.
TLDR: check your coolant level, if its not low, dont waste your money , its the sensor, just unplug it and periodically check your fluid levels.
TLDR: check your coolant level, if its not low, dont waste your money , its the sensor, just unplug it and periodically check your fluid levels.
I would advise against disconnecting or defeating any warning light.
It's around a $100 DIY, and should be fixed correctly.
If someone unplugs their coolant sensor, then a leak could go undetected until the engine overheats, which is VERY BAD!!
I believe the warning light would come on before overheating begins, and most people wouldn't notice the temperature gauge moving until it was already overheating.
#33
Ok, this is an issue I don't agree with.
I would advise against disconnecting or defeating any warning light.
It's around a $100 DIY, and should be fixed correctly.
If someone unplugs their coolant sensor, then a leak could go undetected until the engine overheats, which is VERY BAD!!
I believe the warning light would come on before overheating begins, and most people wouldn't notice the temperature gauge moving until it was already overheating.
I would advise against disconnecting or defeating any warning light.
It's around a $100 DIY, and should be fixed correctly.
If someone unplugs their coolant sensor, then a leak could go undetected until the engine overheats, which is VERY BAD!!
I believe the warning light would come on before overheating begins, and most people wouldn't notice the temperature gauge moving until it was already overheating.
as Cajun stated though, better to fix and have peace of mind and a properly working sensor.
#36
FULLY SEMI AUTOMATIC
iTrader: (9)
#38
Water Foul
If you have had bad coils for a while, and many people do not notice bad trailing coils, you need to inspect your cat for damage. A clogging cat will eventually kill your engine.
Thread
Thread Starter
Forum
Replies
Last Post