Need help identifying a hose...
#1
Need help identifying a hose...
The hose in question is the one in my hand that I'm pretty sure should not be in three pieces...
If anyone knew of where I could find one, that would be even better.
#2
Project Seca
iTrader: (10)
That should go to the throttle body on one side, then out the throttle body to the front cover on the other side. They did a really crappy throttle body bypass mod, they should have bought a new section of heater hose and cut it to length going from the back to the front rather than that awful patchwork. You can either remove the middle section and connect each end back to the ports on the throttle body, or do what I mentioned and get some heater hose so it is one piece cut to length from the back to the front
#3
Registered
Hose looks fine to me, It just has another hose to protect it from getting a hole rubbed in it
Thread
Thread Starter
Forum
Replies
Last Post
RotorMotor04
Series I Aftermarket Performance Modifications
6
07-28-2004 06:42 PM