New here and need help
#1
New here and need help
First, hello I'm Kayla.
Second, I have a gas leak problem in my RX-8. I recently replaced the fuel pump and ever since then, it leaks gas if I try to fill it above a half tank. It doesn't leak driving, it has no trouble starting, it doesn't act weird while driving, and my friend that usually helps me out can't figure it out.
I'm pretty desperate at this point. Thanks for any help.
Second, I have a gas leak problem in my RX-8. I recently replaced the fuel pump and ever since then, it leaks gas if I try to fill it above a half tank. It doesn't leak driving, it has no trouble starting, it doesn't act weird while driving, and my friend that usually helps me out can't figure it out.
I'm pretty desperate at this point. Thanks for any help.
#2
FULLY SEMI AUTOMATIC
iTrader: (9)
where is it leaking gas?
#3
You gonna eat that?
iTrader: (1)
My guess is the fuel ring isn't tightly sealed or it's cross threaded
#4
FULLY SEMI AUTOMATIC
iTrader: (9)
#5
You gonna eat that?
iTrader: (1)
I think because the fuel pump is on the same side as the fuel door and it's a saddle tank, that side gets almost full before it flows over to the other side and it's splashing out.
^^*Could be the clip.
^^*Could be the clip.
#6
You gonna eat that?
iTrader: (1)
Kayla, did you get the fuel ring recall fixed?
If not, bring it to the dealer and they'll fix it for free.
If not, bring it to the dealer and they'll fix it for free.
#8
FULLY SEMI AUTOMATIC
iTrader: (9)
scratch that its leaking in the front of the car? that sounds like fuel line connector. get it fixed asap, they have caused fires before. its under the uim
#9
scratch that its leaking in the front of the car? that sounds like fuel line connector. get it fixed asap, they have caused fires before. its under the uim
#10
You gonna eat that?
iTrader: (1)
[QUOTE=BigCajun;4970426]I think because the
The front passenger side is concerning.
You should put a fire extinguisher in the car just in case.
If you want to rule out the fuel ring or clip, pull up the cushion, remove the cover and have someone watch it as you or your friend put gas in it.
The front passenger side is concerning.
You should put a fire extinguisher in the car just in case.
If you want to rule out the fuel ring or clip, pull up the cushion, remove the cover and have someone watch it as you or your friend put gas in it.
#11
FULLY SEMI AUTOMATIC
iTrader: (9)
a gas leak in the front is a big concern. i would get it checked out right away. where ya from? im sure if a member here is close by someone would check it out for ya
#12
#13
FULLY SEMI AUTOMATIC
iTrader: (9)
i cant think of anyone off the top of my head out there lol. can you post some pics of the leak, maybe under the hood?
#14
You gonna eat that?
iTrader: (1)
Been a while since I've been under one.
Is it possible gas could be leaking out of the tank & traveling under the front passenger side before dripping out?
It seems like a big coincidence the leak would start right after replacing the fuel pump.
Is it possible gas could be leaking out of the tank & traveling under the front passenger side before dripping out?
It seems like a big coincidence the leak would start right after replacing the fuel pump.
#15
It was pouring out from near the gas downspout where you fill it but like at the bottom we're at attaches to the tank it was in that area
The following users liked this post:
200.mph (08-15-2022)
#17
Registered
iTrader: (2)
First, hello I'm Kayla.
Second, I have a gas leak problem in my RX-8. I recently replaced the fuel pump and ever since then, it leaks gas if I try to fill it above a half tank. It doesn't leak driving, it has no trouble starting, it doesn't act weird while driving, and my friend that usually helps me out can't figure it out.
I'm pretty desperate at this point. Thanks for any help.
Second, I have a gas leak problem in my RX-8. I recently replaced the fuel pump and ever since then, it leaks gas if I try to fill it above a half tank. It doesn't leak driving, it has no trouble starting, it doesn't act weird while driving, and my friend that usually helps me out can't figure it out.
I'm pretty desperate at this point. Thanks for any help.
#19
RX-Heaven
iTrader: (6)
Where the filler neck attaches, there are no other lines that could leak there. There's a lock ring for a fuel level sender near the filler neck however. If that was removed, the o-ring that seals the sender to the tank should be have been replaced. I use a tiny amount of rubber grease on the new o-ring and lubricate it before I torque the lock ring. I do this so that the o-ring does not Bing and roll. If this happens, rhe tank will leak gas and it will set a code for a large evap leak. Have you scanned the car for any current or pending codes?
You can also remove the back seat cushion on the passenger side. You will lift it up in the front and then its held in by two bolts at the rear. Once removed you will remove the small metal access plate that's held in by four screws. Once that's removed you can inspect the lock ring for leakage. Same applies to the other side. Perhaps removing either will help you find the source of the leak.
You can also remove the back seat cushion on the passenger side. You will lift it up in the front and then its held in by two bolts at the rear. Once removed you will remove the small metal access plate that's held in by four screws. Once that's removed you can inspect the lock ring for leakage. Same applies to the other side. Perhaps removing either will help you find the source of the leak.
#20
You gonna eat that?
iTrader: (1)
I asked if the fuel ring recall was done.
A response would be helpful.
A response would be helpful.
#21
You gonna eat that?
iTrader: (1)
#22
Hello, I'm new to the forum and I've got a 2005 RX8 with an automatic. 4 port.
Currently it is not running. The previous owner, my friend, not a hotrodder or street racer at all, said it was running well but one day white smoke appeared from the exhaust..
I am planning on tackling the engine rebuild myself with the help of a friend who is a qualified mechanic.
I have a few questions I was hoping to get answered.
I'm assuming it needs either a new engine or at least an engine rebuild. After looking at a lot of websites I contacted the Canadian Rotaryengine.com, RX7 Specialties to buy engine gaskets and seals
for the rebuild. I understand that they can refinish the side housings and if the rotor housings are in good shape they can hone the surface.
It has been difficult for me to get an answer on what parts I need or how much this will cost. Of course they do not want to commit without seeing the parts.
I was hoping to get some good resources for other businesses that may sell the parts I need. Where is a good place to buy all of the gaskets that I need?
Suggestions?
I am also looking at used JDM Ebay motors from a place in New York. Does anyone here have any experience with used eBay motors?
Thanks in advance for any help!
Currently it is not running. The previous owner, my friend, not a hotrodder or street racer at all, said it was running well but one day white smoke appeared from the exhaust..
I am planning on tackling the engine rebuild myself with the help of a friend who is a qualified mechanic.
I have a few questions I was hoping to get answered.
I'm assuming it needs either a new engine or at least an engine rebuild. After looking at a lot of websites I contacted the Canadian Rotaryengine.com, RX7 Specialties to buy engine gaskets and seals
for the rebuild. I understand that they can refinish the side housings and if the rotor housings are in good shape they can hone the surface.
It has been difficult for me to get an answer on what parts I need or how much this will cost. Of course they do not want to commit without seeing the parts.
I was hoping to get some good resources for other businesses that may sell the parts I need. Where is a good place to buy all of the gaskets that I need?
Suggestions?
I am also looking at used JDM Ebay motors from a place in New York. Does anyone here have any experience with used eBay motors?
Thanks in advance for any help!
The following users liked this post:
200.mph (08-15-2022)
#24
Im in California, and im assuming buying an engine from mazda would be fairly expensive
Last edited by Pierre (rx8); 08-15-2022 at 12:46 PM.
#25
FULLY SEMI AUTOMATIC
iTrader: (9)