Oil light flashing no beep no check engine codes after belt change
#1
New Member
Thread Starter
Join Date: Sep 2021
Location: Florida
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Oil light flashing no beep no check engine codes after belt change
2010 grand touring 6 speed
I just changed my belts for both drive and ac.(ac belt failed ) When I took it for a short drive to check to see if my ac was working again ( it's not. It's now showing low pressure ) the oil light started flashing and the car died I was able to restart by both key and 3rd dump. When I got back home I checked and sure enough I left a vacuum line in done (small line on left of air box if looking towards the rear) I reconnected it and did the brake pump reset I read about but no luck still getting flashing with full oil any help would be great as I daily drive my 8.
I just changed my belts for both drive and ac.(ac belt failed ) When I took it for a short drive to check to see if my ac was working again ( it's not. It's now showing low pressure ) the oil light started flashing and the car died I was able to restart by both key and 3rd dump. When I got back home I checked and sure enough I left a vacuum line in done (small line on left of air box if looking towards the rear) I reconnected it and did the brake pump reset I read about but no luck still getting flashing with full oil any help would be great as I daily drive my 8.
Thread
Thread Starter
Forum
Replies
Last Post
Waylon Chen
New Member Forum
17
02-05-2014 06:31 PM
dbdbdb
Series I Tech Garage
27
08-16-2007 08:48 AM