Rx8 Inputshaft Bearing
#1
Rx8 Inputshaft Bearing
Hey ive pulled my trans to do a clutch and am wanting to get the noisy input shaft bearing done at the same time, it does have a fair bit of play.
Just wondering how would i go about getting it out, the bearing actualy feels loose but there is somthing stoping it from coming out, do i need to split the transmission?
i do have a video just need to find out how to post it
Ive found this clip which appears to be stopping it. Ive never seen one like this before am i going to be needing a special tool?
Just wondering how would i go about getting it out, the bearing actualy feels loose but there is somthing stoping it from coming out, do i need to split the transmission?
i do have a video just need to find out how to post it
Ive found this clip which appears to be stopping it. Ive never seen one like this before am i going to be needing a special tool?
Last edited by rxs; 07-16-2023 at 09:24 PM. Reason: adding photo
Thread
Thread Starter
Forum
Replies
Last Post
xanex18
Series I Tech Garage
8
12-27-2017 03:50 PM
RotaryDrama
New Member Forum
4
08-29-2014 07:03 AM