Notices
New Member Forum A place for new members to get their feet wet

Starts up but stalls when hot only sometimes

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 12-28-2016 | 09:56 PM
  #1  
Trex87's Avatar
Thread Starter
Registered
 
Joined: Feb 2016
Posts: 176
Likes: 1
Starts up but stalls when hot only sometimes

Sometimes my car's idle drops to 700 after I start it after a hard drive. Today after hard drive I started it up and it died.. it did it again right afterwards. Compression tested fine by a rotory specialist couple weeks ago. Any ideas? Vacuum leak? My cat is gutted. I have p2070 at the moment and I will be taking care of that soon. Maf is 4.6 at idle, vacuum almost 19in at idle, ltft is 10 stft is 2.

06 MT 106k
Old 12-28-2016 | 10:41 PM
  #2  
tgaffner's Avatar
Registered
 
Joined: Aug 2015
Posts: 266
Likes: 8
I would highly recommend looking into a new fuel pump. They are problematic on S1
Old 12-29-2016 | 03:04 AM
  #3  
swoope's Avatar
Zoom-Freakin'-Zoom
iTrader: (5)
 
Joined: Jan 2004
Posts: 14,602
Likes: 36
From: orlando, fl
Originally Posted by Trex87
Sometimes my car's idle drops to 700 after I start it after a hard drive. Today after hard drive I started it up and it died.. it did it again right afterwards. Compression tested fine by a rotory specialist couple weeks ago. Any ideas? Vacuum leak? My cat is gutted. I have p2070 at the moment and I will be taking care of that soon. Maf is 4.6 at idle, vacuum almost 19in at idle, ltft is 10 stft is 2.

06 MT 106k
or you can just be on cruise with low fuel and car shuts off.. same issue. fuel pump overheats..

things i know.

beers
Old 12-29-2016 | 03:58 AM
  #4  
Trex87's Avatar
Thread Starter
Registered
 
Joined: Feb 2016
Posts: 176
Likes: 1
Thanks guys. I did replace the fuel pump about 7k ago, but I'll get that adaptor and check the fuel pressure.
Old 12-29-2016 | 09:33 AM
  #5  
Trex87's Avatar
Thread Starter
Registered
 
Joined: Feb 2016
Posts: 176
Likes: 1
So I know the pressure has to be from around 47 to 53 psi if I recall correctly. Should I test at idle and 2.5k rpm?
Old 12-29-2016 | 11:22 AM
  #6  
Trex87's Avatar
Thread Starter
Registered
 
Joined: Feb 2016
Posts: 176
Likes: 1
OK so no matter what situation the pressure should be as you mentioned?
Old 12-29-2016 | 11:43 AM
  #7  
9krpmrx8's Avatar
SARX Legend
iTrader: (46)
 
Joined: Jan 2007
Posts: 33,786
Likes: 455
From: San Antonio, Texas
Yes, even when the car is off pressure doesn't drop but only a couple of PSI.
Old 12-29-2016 | 02:31 PM
  #8  
9krpmrx8's Avatar
SARX Legend
iTrader: (46)
 
Joined: Jan 2007
Posts: 33,786
Likes: 455
From: San Antonio, Texas
TX

Originally Posted by Charles R. Hill
IIRC, the factory spec is to hold the fuel system pressure for 30 minutes, or so...... something like that, anyway.
Mine holds overnight, I discovered all this when mine was not holding pressure and causing hard starts when cold. I have never checked it for any longer than that.

This was with the unknown leak, with the leak fixed it's usually at 60psi and with the S2 starter, it turns over with barely a bump of the key..


Last edited by 9krpmrx8; 12-29-2016 at 02:34 PM.
Old 02-17-2017 | 10:50 AM
  #9  
Trex87's Avatar
Thread Starter
Registered
 
Joined: Feb 2016
Posts: 176
Likes: 1
An update to the thread, I finally got to checking the pressure, it's at a solid 60psi. The only time it was low was after I put the pump fuse back after taking it out to drain the fuel from the lines. It built up after a few key turns



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 11:22 AM.