Tester specs and ?'s - RX8Club.com

04-11-2016 | 06:14 PM

Rotary Compression Tester.Com

Thread Starter

RX8Club.com Sponsor

Joined: Mar 2016

Posts: 173

Likes: 13

Tester specs and ?'s

http://rotatrycompressiontester.com

As you can see above the RCT-V5 digital handheld Rotary compression tester was developed and tested right beside the same compression tester that probably 85% of dealers still use today!

I have started this Thread to give you some specs, and for your ?'s

1) The RCT-V5 is a digital handheld and self contained unit that runs on a single 9v battery.

The tester & sensor done!

No PC or laptop needed, no bulky adapters causing dead volume, or outside power source needed.

2) Flame retardant abs case

3) We give you the latest technology inside, and only source the best parts from all over the world.

4) Tester cord is 5 1/2 feet long, you can set in the driver seat and perform the test yourself.

5) The sensor itself is machined from billet stainless to fit any Wankel rotary engine, 99% accurate between 40-140 PSI.
No calibration needed ever, once computer coding was set (see above) every Tester & Sensor read exactly the same. I will test each unit and sensor individually to ensure quality!

Sensor is capable of well more than required PSI to test any rotary engine.
Tester cord and sensor connect with a simple and easy to use mini 3-pin din plug.

The Sensor will work flawlessly with any fuel type Unleaded, E85, and Methanol.
Also works with any oil type!

6) All digital handheld rotary compression tester units comes with a protective silicone boot to protect your tester, if you choose to upgrade to military style boot that is up to you. You choose color (red,blue,yellow,grey, and black. I can special order other colors, at an additional cost just not stocking them.

7) Overlay with operating instruction right on TOP is both water and oil resistant.

8) Every RCT-V5 unit purchased from Rotary CompressionTester.com will come with a Shock proof case to store unit and sensor in, when not in use.

Anything more than that is really proprietary in formation, and you are more than welcome to take the next 18 months and over $20k to figure it out!

If it was that easy to perfect the market would be flooded and I would of never took on the challenge of manufacturing and moving a company halfway @ the world.

If you have any ?'s feel free to ask, I hope I've covered most your of your questions.

Have a great day everyone...........

Last edited by Rotary Compression Tester.Com; 04-11-2016 at 07:01 PM.