13bre swap
#126
Uncontrollable drifter
Thread Starter
Finally made a new oil pan, the stock 13bre sits way too low to the ground. I used a stock RX8(which is very shallow, but a very clever idea with the oil reservoir) and a 13BRE and mated them together. I braze welded it and it came out really good and no leaks!
Last edited by dznutzuk; 12-19-2010 at 08:58 AM.
#128
Clever solution.
#130
Going for broke
How about a status update on how the cars runnig and performing?
#134
Going for broke
#135
Going for broke
#136
Uncontrollable drifter
Thread Starter
Car is running pretty good, funnily enough I'm getting the same gas mileage as I did with the bone stock RX8. I'm not a big fan of the stock 6speed tranny-1st,2nd,3rd are useless. I have to get my FD transmission in it and see how it does.
Last edited by dznutzuk; 12-10-2010 at 01:34 AM.
#138
Registered
Join Date: Nov 2005
Location: Victoria BC Canada
Posts: 207
Likes: 0
Received 0 Likes
on
0 Posts
It will do just fine...Speaking from experience ofcoarse
#142
Uncontrollable drifter
Thread Starter
Well if you read all the pages of the thread you'll see that the manifold was custom made with 2inch ss bends, the turbo was a KKK K28/29. I'm using a older haltech e6k since I had it leftover from my previous FD. I'm using the classical setup of 550cc primaries and 1680cc secondaries. But read over the pages and look at the photos and you'll pretty much get the idea of what went on.
#146
Registered User
Join Date: Aug 2011
Location: Fort Mill, SC
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Lower Intake Manifold - Who made it?
I know this is a forever long ago thread but what LIM did you finally end up going with? What company makes it and where can it be purchased?
Thanks,
Jeremy
Thanks,
Jeremy
#147
Registered
iTrader: (25)
To this: http://www.xcessivemanufacturing.com...&step=4&pid=17
.