Bad rx8
05-02-2010, 06:35 AM
#151
Registered
Thread Starter
Join Date: Jul 2007
Location: Australia
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Hi all, thanks again for all the good comments, it means alot when you have put so much into the car. its good to see the headaches paying off. still having dramas getting the car running though, hopefully i get the clutch issue sorted soon.
another problem im having is with the Davies Craig electric water pump, i think im getting an error with the temp sensor.
On a positive note i have my gauges, boost controller (still need to secure with double side tape) and exhaust cut out valve installed.
another problem im having is with the Davies Craig electric water pump, i think im getting an error with the temp sensor.
On a positive note i have my gauges, boost controller (still need to secure with double side tape) and exhaust cut out valve installed.
05-02-2010, 03:41 PM
#154
does any one know where i can get an english instruction manual 
06-13-2010, 01:43 AM
#155
Registered
Thread Starter
Join Date: Jul 2007
Location: Australia
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
So i have finally got this thing finished and couldnt be happier 
here is a couple of pics of it sitting nice and a new vid.
http://www.youtube.com/watch?v=RjIF01BL64E
here is a couple of pics of it sitting nice and a new vid.
http://www.youtube.com/watch?v=RjIF01BL64E
06-13-2010, 02:06 AM
#157
Registered
Thread Starter
Join Date: Jul 2007
Location: Australia
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
11-16-2010, 05:12 AM
#168
Registered
Thread Starter
Join Date: Jul 2007
Location: Australia
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Hello again. I went out for a cruize with my friend and decided to take a couple of snaps. His Bima is pretty wild, take a close look at the front seats 
11-16-2010, 06:00 AM
#169
11-23-2010, 02:10 AM
#173
Registered
Thread Starter
Join Date: Jul 2007
Location: Australia
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the comments guys 
the car is going well.
I will be getting it tuned very soon which leads me to a question for all you with the wealth of knowledge. on my blitz sbc icolor, where do i connect the speed sensor wire to the car?
the car is going well.I will be getting it tuned very soon which leads me to a question for all you with the wealth of knowledge. on my blitz sbc icolor, where do i connect the speed sensor wire to the car?
03-20-2011, 06:42 PM
#174
Registered
Thread Starter
Join Date: Jul 2007
Location: Australia
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
It has been a while since I have had a reason to post in my thread but I am now excited to say I have finally managed to get my car on the dyno. Ive included a couple of recent pics and the dyno sheet.
