Attained 15000 rpm with my engine; no problems
#28
Registered
Thread Starter
Well, I never mentioned "Rx-8", "car", "Mazda" or anything like that. Everything I wrote was literally correct. If you misinterpreted it, then I'm sorry
#39
Registered
Thread Starter
And no, as far as I know no one tried to make a birotor engine out of these. But there have been several twin engined wankel airplanes.
#43
Out of NYC
iTrader: (1)
if its just mis-shift and it pops up off the tach chart, the Flywheel should stay and u should be alive (and engine/tranny/drivetrain should be fine as well)
but if you're talking about, using 3rd party or even strip the ECU and use Motec to try to get it to 15K at all times. Well, good luck to your leg or whoever in the passenger side. u'll be lucky if the flywheel flies down instead of going up somewhere.
but if you're talking about, using 3rd party or even strip the ECU and use Motec to try to get it to 15K at all times. Well, good luck to your leg or whoever in the passenger side. u'll be lucky if the flywheel flies down instead of going up somewhere.
#46
Banned
Join Date: Sep 2007
Location: Waukesha Wisconsin
Posts: 2,643
Likes: 0
Received 0 Likes
on
0 Posts
#49
Actually guys......My Mazda tech told me OUR CAR ENGINES are dynoed at about 14K. They have rev limiters and fuel cutoffs for safety reasons of course to be used on the streets....and thats why when you accidentally hit 10K or higher in the "wrong" gear they DON'T fly all to pieces....He didn't recommend it's done all the time, but it won't hurt it. I hit 10K in first and second tonight, with a cold engine at 40 degrees and it's not garage parked. The car had not been cranked in 2 days and it was 28 last night..no problems...