DIY automatic to manual-look??
#1
DIY automatic to manual-look??
I have an automatic model and the shifter cover is made of cheap plastic. I want to change it. I found that automatic shifter cover and manual shift boot are same size. But the Automatic shift **** is longer than manaul's. Is automatic shifter cover removable? If it is possible, I will remove the automatic shifter cover, install the manual shift boot and replace shift **** also. Any idea for this plan? Possible?
Last edited by reverse01134; 03-08-2010 at 12:09 AM.
#3
I don't need to see where the shift position is. 1 P -> 2. R -> 3. N -> 4. D -> Left. M it is easy. Also dashboard tells what position I am in.
Last edited by reverse01134; 03-07-2010 at 11:52 PM.
#5
Registered Lunatic
iTrader: (1)
Joined: Aug 2003
Posts: 3,581
Likes: 38
From: SF Bay Area, California
I think there were some pics posted where the auto shifter cover was replaced with the manual shift boot. It looked good.
Unless you WANT to have a different shifter ****, I would leave the stock one alone because it looks just fine IMO.
Unless you WANT to have a different shifter ****, I would leave the stock one alone because it looks just fine IMO.
#6
you will end up just tricking yourself cause everyone that will know car will know it's an auto, and may result in them looking down on "wannabes"
there are however ways to change it, even cutting it so it's "lower"
there are however ways to change it, even cutting it so it's "lower"
#8
And I don't think the stock automatic shift **** will match with leather shift boot.