engine problems
#1
engine problems
Hey I am wondering what could cause my engine to stall for no reason, it happens when I'm idoling, it moves below 1k then pops back up and then just goes all the way to zero.
#4
ok. i have an 2004 mazda rx8, with new sparkplugs, ignition coils, sparkplug wires, engine mounts, the mods i have done are short ram intake(good sound), and a catback exhaust. the dealer said its carbon buildup.
#5
Registered User
he is could be right. Do try what I suggested I had the same problem last summer and then I started to use injector cleaner and it worked very well.. so give it a shot
#6
kevin@rotaryresurrection
iTrader: (3)
Join Date: Feb 2005
Location: east of Knoxville, TN
Posts: 1,415
Likes: 0
Received 57 Likes
on
35 Posts
#1 rule of rotary engine troubleshooting...compression test.
Also you can try to remove the throttle body, gently push the blade open and hold it, and clean the blade tips and throttle body of carbon/oil buildup, and it may help your idle a bit.
99% of the time difficulty starting and idling in a rotary is due to weak compression from a worn out engine.
Also you can try to remove the throttle body, gently push the blade open and hold it, and clean the blade tips and throttle body of carbon/oil buildup, and it may help your idle a bit.
99% of the time difficulty starting and idling in a rotary is due to weak compression from a worn out engine.
#8
Registered
#10
Registered User
I just think its his injectors, run some cleaner and rev it hard and it might go away.. thats the cheapest and easiest way, if that does not work clean the throttle and then go and see if it is your intake that is causing the problem
yey 400th post
yey 400th post
#13
Registered
Thread
Thread Starter
Forum
Replies
Last Post
xAgyex
Series I Trouble Shooting
19
11-13-2023 07:51 AM
Audio Concepts ATL
New Member Forum
21
09-26-2021 01:59 PM