m flash with cz unit ok?
#1
Banned
Thread Starter
Join Date: Apr 2004
Location: New York
Posts: 299
Likes: 0
Received 0 Likes
on
0 Posts
m flash with cz unit ok?
Today, i had the CZ 1.1 mod in, and went to the dealer for a 5k service... I don't think the Mazda service station realized the unit was in because i forgot to turn it off...
Well, i got the MSP04 (i think that is the m-flash) done today with the CZ 1.1 unit installed...
Is that oK?
I am asking because i know the cz unit reads and learns the ecu, but not sure if the unit is ok if it is reflashed with the unit still on...
can someone help me on this??
I have yet to drive it because my keys JDM key is being programmed.
Well, i got the MSP04 (i think that is the m-flash) done today with the CZ 1.1 unit installed...
Is that oK?
I am asking because i know the cz unit reads and learns the ecu, but not sure if the unit is ok if it is reflashed with the unit still on...
can someone help me on this??
I have yet to drive it because my keys JDM key is being programmed.
#2
Registered User
Join Date: Jul 2003
Location: Edmonton
Posts: 680
Likes: 0
Received 0 Likes
on
0 Posts
It'll be fine. Our unit is only actually connected to TPS, MAF, and the ignition outputs. None of those has anything to do with the programming signals. You will probably want to get the latest map in the Canzoomer unit. You will need the programming cable and program to put it in yourself. The latest maps are optimized for the "M" flash. If your unit is fairly new, it will be set up for the "M" flash (from May 5 and on). There is a new map out that is, of course, better . It was done last week.
Thread
Thread Starter
Forum
Replies
Last Post
ShellDude
RX-8 Parts For Sale/Wanted
5
10-01-2015 09:55 PM