Notices
RX-8 Discussion General discussion about the RX-8 that doesn't fit in one of the specialty forums.
Sponsored by:
Sponsored by: CARiD

oops

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 03-07-2004 | 10:08 PM
  #1  
JERCS's Avatar
Thread Starter
Awesome Member
 
Joined: Feb 2004
Posts: 305
Likes: 0
From: SLC, UTAH
oops

I had to break into my 8 this weekend with a drill (scary!), we drilled through the "popper" of the back window in the suicide door. I know it sounds stupid but we had our reasons, like we were to far to wait for a locksmith… plus like an idiot the car was running.

The part I need is the black round cap that the “popper” screws into, it’s on the outside of the window. Mazda wants $185 for the entire popper, but all I need is that dang cap!

I made a temp fix, but would like it back to normal. Anyone have any ideas?
Old 03-07-2004 | 10:15 PM
  #2  
brothervoodoo's Avatar
RainMan is Back
 
Joined: May 2003
Posts: 2,650
Likes: 0
From: SF Bay Area
So how did you lock the door with the car running? I think my car will not allow me to lock an open door when the engine is running? You can only lock it when the door is closed and presumbly that can only happen when somebody is in the car....
Old 03-07-2004 | 10:30 PM
  #3  
JERCS's Avatar
Thread Starter
Awesome Member
 
Joined: Feb 2004
Posts: 305
Likes: 0
From: SLC, UTAH
Originally posted by brothervoodoo
So how did you lock the door with the car running? I think my car will not allow me to lock an open door when the engine is running? You can only lock it when the door is closed and presumbly that can only happen when somebody is in the car....
Yeah i know. No idea how the hell I did it... doesn't make sense but I did.
Old 03-07-2004 | 10:49 PM
  #4  
DemonRX-8's Avatar
I got nothing good to say
 
Joined: Jan 2004
Posts: 450
Likes: 0
From: Tysons Corner, VA
I've actually tried to lock the car with it running (to let it warm up during the cold weather) with the extra keyless entry fob, but it still wouldn't let me do it!
Old 03-07-2004 | 11:00 PM
  #5  
ranger4277's Avatar
Cones need lovin' too!
 
Joined: Aug 2003
Posts: 649
Likes: 0
From: Beavercreek, Ohio
Can we not lock the 8 by holding the inside door latch open and then manually locking the door? I'll try it in the morning... I'd be surprised if we can't.
Old 03-08-2004 | 04:10 AM
  #6  
RobDickinson's Avatar
Registered User
 
Joined: Mar 2003
Posts: 1,571
Likes: 1
Only wai I have managed to lock the car with the engin running is by using the spare set of keys and actualy using the KEY in the door to lock.

Fob buttons dont work.
Old 03-08-2004 | 09:15 AM
  #7  
mamccubbin's Avatar
Bert angry!
 
Joined: Aug 2003
Posts: 337
Likes: 0
From: Madison, WI
Couldn't you just manually flip the lock switch on the door?
Old 03-08-2004 | 09:20 AM
  #8  
RobDickinson's Avatar
Registered User
 
Joined: Mar 2003
Posts: 1,571
Likes: 1
Originally posted by mamccubbin
Couldn't you just manually flip the lock switch on the door?
Not from outside :P
Old 03-08-2004 | 11:46 AM
  #9  
Sue Esponte's Avatar
Grand Poobah
 
Joined: Feb 2004
Posts: 398
Likes: 0
From: New England
Why didn't the key fob work?

-Eric
Old 03-08-2004 | 04:00 PM
  #10  
mamccubbin's Avatar
Bert angry!
 
Joined: Aug 2003
Posts: 337
Likes: 0
From: Madison, WI
Originally posted by RobDickinson
Not from outside :P
I didn't mean to unlock the car, but to lock it. People said they couldn't lock the car with it running.
Old 03-08-2004 | 04:27 PM
  #11  
ranger4277's Avatar
Cones need lovin' too!
 
Joined: Aug 2003
Posts: 649
Likes: 0
From: Beavercreek, Ohio
Well I tried locking it by holding the inside door latch open and manually locking it... but with the engine running it auto unlocks every time. Neat feature.... you must have really done something screwy to lock yourself out.
Old 03-08-2004 | 05:25 PM
  #12  
FirstSpin's Avatar
Registered User
 
Joined: Dec 2003
Posts: 225
Likes: 0
From: Houston, TX
That's been my experience too. I've bumped my lock-switch when getting out of the car to check the mail (with the car running). Even though the switch gets pressed in (fully locked), it immediately springs back out (unlocked) refusing to let me lock my keys in the car (thank god for that!!).
Old 03-08-2004 | 06:13 PM
  #13  
EstonRX's Avatar
Registered User
 
Joined: Feb 2004
Posts: 94
Likes: 0
From: Fremont, California
As far as how to get the part without spending $185, I'd check totalled RX-8's, or people that have had that whole panel replaced (the rear door I s'pose). Shouldn't be hard to convince somebody with a spare dented up door or a totalled car to part with the piece for a few bucks.

I know somebody has been selling a totalled 8 on ebay. How much less would he get without that little cap?
Old 03-08-2004 | 06:15 PM
  #14  
MazdaManiac's Avatar
Banned
iTrader: (3)
 
Joined: Oct 2003
Posts: 16,386
Likes: 26
From: Under my car
Yeah, I'm not sure how you managed to lock the keys in.
Old 03-09-2004 | 03:37 AM
  #15  
mlino01's Avatar
Registered User
 
Joined: Jan 2004
Posts: 142
Likes: 0
From: Elk Grove CA
He probably used the vallet key.
Old 03-09-2004 | 03:49 AM
  #16  
RobDickinson's Avatar
Registered User
 
Joined: Mar 2003
Posts: 1,571
Likes: 1
let me try again.

With the key in and the engine running you can lock the door with another key, using the keyhole, place key in hole, turn.

Lock button on fob wont work (wont even open the boot), neither will trying the lock latch on the internal door handle.

Using 2 keys is the only way I know how to lock the car with the engine running.
Old 03-09-2004 | 10:39 AM
  #17  
JERCS's Avatar
Thread Starter
Awesome Member
 
Joined: Feb 2004
Posts: 305
Likes: 0
From: SLC, UTAH
Originally posted by RobDickinson
let me try again.

With the key in and the engine running you can lock the door with another key, using the keyhole, place key in hole, turn.

Lock button on fob wont work (wont even open the boot), neither will trying the lock latch on the internal door handle.

Using 2 keys is the only way I know how to lock the car with the engine running.
Or somehow pushing the lock in on the door. And then shutting it. Like I did.
Old 03-16-2004 | 03:51 PM
  #18  
LambertRX8's Avatar
Registered User
 
Joined: Sep 2003
Posts: 117
Likes: 0
From: Sorrento, Florida
Last night I filled up for gas, left keys dangling in ingnition as to stop annoying noise, got out - checked oil and cleaned windows. I shut the door as I passed by it but dont remember locking it. When I went to leave I was locked out, keys dangling from the ignition.

Only saving grace was when I got out I popped the hood and trunk at same time to check oil and get oil if I needed it. I kicked in the rear center cover and fished the keys with my golf ball retriever.

I guess the keys can be locked in the car even when it is not running.

DON"T DO THIS AT HOME!!!!
Old 03-16-2004 | 07:16 PM
  #19  
JERCS's Avatar
Thread Starter
Awesome Member
 
Joined: Feb 2004
Posts: 305
Likes: 0
From: SLC, UTAH
haha. Good ol' golf :D yours should be less expensive then my oops
Old 03-16-2004 | 11:09 PM
  #20  
TPNova1's Avatar
Registered User
 
Joined: Feb 2004
Posts: 69
Likes: 0
From: Philadelphia Area
That is the fail-safe, ...the only way to lock the car while engine running is with a 2nd key turning the lock once outside and the door shut. This is the only way unfortunately to start the RX-8, and let it warm and walk away at the same time...all leaving it locked; and when you come back 5 minutes later, use your 2nd key to manually unlock the door.
Old 03-16-2004 | 11:14 PM
  #21  
JERCS's Avatar
Thread Starter
Awesome Member
 
Joined: Feb 2004
Posts: 305
Likes: 0
From: SLC, UTAH
you don't need the 2nd key to lock it, just push it the lock on the door.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
CMRine04
Series I Wheels, Tires, Brakes & Suspension
5
09-17-2015 11:04 AM
daisuke
Series I Wheels, Tires, Brakes & Suspension
6
06-10-2008 11:58 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 10:19 PM.