Quick question about the throttle bottle
#1
1SIK8
Thread Starter
Quick question about the throttle bottle
My 04 RX8 (61.XXXmiles) has been idling kinda funny lately at a stop the idle would drop to 500 then go back up, so I've been doing some reading on here and the first easy task was to clean the MAF and TB. My question..... is the TB Blade supposed to sit flush to where i push it in(Closing) it dont move or is it supposed to have some slack to where i can push it in just a little?
#5
1SIK8
Thread Starter
You see i wondered about that myself Charles but when i Google my question there was a topic on here that someone had mentioned that the butterfly needed to be closed complete.
#6
1SIK8
Thread Starter
Ohh by the way after i cleaned the MAF Sensor and TB my RPMs are at 1000 but when i rev it just a bit it goes to 1500 and and stays for a couple sec's then comes down slowly.....
#7
That's normal, is supposed to do that. The gap in your throttle body is also normal, it's commonly referred to as the idle gap.
#8
FULLY SEMI AUTOMATIC
iTrader: (9)
whats a throttle bottle?
Thread
Thread Starter
Forum
Replies
Last Post
gwailo
New Member Forum
38
05-14-2024 06:57 AM
LMURailsplitter02
New Member Forum
1
09-06-2015 10:56 PM
badinfluence
Series II Aftermarket Performance Modifications
6
08-31-2015 11:51 AM