RX-8 Issues
07-22-2008, 01:11 PM
#26
Registered
iTrader: (1)
Join Date: Sep 2002
Location: Aliso Viejo, ca
Posts: 454
Likes: 0
Received 0 Likes
on
0 Posts
Man, taht sucks and doesnt make sense at all.. if there was no issue with the motor mounts and a replacement engine needs new mounts to make it not vibrate, how the hell can they charge for that? That is wacked.. Wonder if others with engine replacement was charged 5 bills for new mounts
07-22-2008, 01:18 PM
#27
Registered
iTrader: (1)
Join Date: Apr 2006
Location: Plano, TX
Posts: 522
Likes: 0
Received 0 Likes
on
0 Posts
That is the worst part about this car. God forbid if you have to service it at the dealer.
Mine still cant seem to hear a throw out bearing noise that my girlfriend and I always hear.....
Mine still cant seem to hear a throw out bearing noise that my girlfriend and I always hear.....
07-22-2008, 03:39 PM
#29
Registered
Too late since you've paid, but it seems like you could have said you didn't authorize the work, and they should just put the old ones back.
Of course, since this is the place that claimed the new motor was bigger and needed pads, there's no telling what they would have done. You're probably lucky to escape with your life.
Ken
07-22-2008, 04:20 PM
#30
I am having trouble w/ flooding, and not the typical flooding issue. This happens everytime I put a load on the engine. If I rev up the RPM's while going up a hill and then the next complete stop I have, the car will stall and it acts flooded. If I wait a couple of minutes the car will turn over and then I am good to go...BUT it doesn't stop there, if I turn off the car, it acts flooded again, only when I let it sit for an hour or so does it act normal again. Has anyone else had this problem, and if so what fixed it?
Thank you!
Thank you!
Thread
Thread Starter
Forum
Replies
Last Post
dbarber
Series I Trouble Shooting
14
07-25-2015 01:34 PM
