Notices
RX-8 Discussion General discussion about the RX-8 that doesn't fit in one of the specialty forums.
Sponsored by:
Sponsored by: CARiD

Slip light is on since I re-connect the battary

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 03-31-2010 | 12:13 PM
  #1  
reverse01134's Avatar
Thread Starter
Registered
 
Joined: Feb 2010
Posts: 68
Likes: 0
Slip light keeps on since I re-connect the battary

I disconnected and connected the battary again to remove the radio. everything works fine but since I re-connected the battary, slip light keeps on. DSC off light was flashing too but it disappeared after driving a minute. but the slip light keeps on. What is wrong with it? anyone has this experience?

Last edited by reverse01134; 03-31-2010 at 12:19 PM.
Old 03-31-2010 | 12:36 PM
  #2  
Huey52's Avatar
Registered Zoom Zoomer
iTrader: (2)
 
Joined: Apr 2006
Posts: 4,089
Likes: 6
From: New England
Slip light? There is a common TCS/DCS light.

"This indicator light stays on for a few
seconds when the ignition switch is turned
to the ON position. If the TCS or DSC is
operating, the indicator light flashes.
If the light stays on, the TCS or DSC may
have a malfunction and they may not
operate correctly. Take your vehicle to an
Authorized Mazda Dealer.
NOTE
l In addition to the indicator light
flashing, a slight lugging sound will
come from the engine. This indicates
that the TCS is operating properly.
l On slippery surfaces, such as fresh
snow, it will be impossible to
achieve high rpm when the TCS is on."

"If the battery is disconnected, the DSC
will be inoperable. In this case, the DSC
OFF indicator light flashes and the
TCS/DSC indicator light illuminates.
To make the DSC operable, do the
following procedure.
1. Turn the ignition switch to the ON
position.
2. Turn the steering clockwise fully,
then turn it counterclockwise fully.
3. Make sure the DSC OFF indicator
goes off.
4. Turn the ignition switch to the OFF
position, then turn it to the ON
position again.
5. Make sure the TCS/DSC indicator
light goes off.
If the TCS/DSC indicator light and the
DSC OFF indicator light remain
illuminated even after turning the
ignition switch to the ON position,
consult an Authorized Mazda Dealer."

(an Owner's Manual is a wonderful thing)
Old 03-31-2010 | 01:11 PM
  #3  
dillsrotary's Avatar
jersey fresh
 
Joined: Dec 2005
Posts: 3,688
Likes: 0
From: Boston, MA
^ding ding!
Old 03-31-2010 | 02:32 PM
  #4  
Rota II's Avatar
Its better the 2nd time
 
Joined: Dec 2009
Posts: 112
Likes: 0
From: Fort Laud. FL
WOW... I was gonna answer his question becasue i knew the anwser, but HOLY COW Huey, nice answer! Although, you didnt give him the page number. LOL
Old 04-01-2010 | 07:32 AM
  #5  
Huey52's Avatar
Registered Zoom Zoomer
iTrader: (2)
 
Joined: Apr 2006
Posts: 4,089
Likes: 6
From: New England
^ LOL, but thanks. Just a simple cut & paste from my .pdf version of the manual, which is readily available to anyone, by model year, on Mazda's site (just sign up as an owner).
Old 04-01-2010 | 12:05 PM
  #6  
Pico's Avatar
It's Complicated
iTrader: (2)
 
Joined: Feb 2008
Posts: 1,780
Likes: 0
From: Dirty Jerz
Huey to the rescue.

Owners manual is your friend
Old 04-01-2010 | 01:14 PM
  #7  
Grungepup's Avatar
Oilfield trash
iTrader: (2)
 
Joined: Feb 2008
Posts: 2,509
Likes: 0
damn i knew this one too....
Old 04-01-2010 | 05:39 PM
  #8  
MazdaManiac's Avatar
Banned
iTrader: (3)
 
Joined: Oct 2003
Posts: 16,386
Likes: 26
From: Under my car
Synopsis:

Turn your steering wheel both ways to the lock and cycle the ignition.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
projectr13b
RX-8 Racing
20
05-14-2016 06:25 PM
cliffkemp
Series I Trouble Shooting
7
10-03-2015 11:11 PM
jasonrxeight
RX-8's For Sale/Wanted
2
09-30-2015 01:53 PM
xAgyex
RX-8 Parts For Sale/Wanted
0
09-28-2015 08:54 AM
Evan Gray
Series I Trouble Shooting
0
09-26-2015 12:30 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: Slip light is on since I re-connect the battary



All times are GMT -5. The time now is 09:18 AM.