Notices
RX-8 Discussion General discussion about the RX-8 that doesn't fit in one of the specialty forums.
Sponsored by:
Sponsored by: CARiD

well i just got the famous FLOODING prob!! arrrgh

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 04-30-2008 | 11:38 AM
  #1  
tvtech3's Avatar
Thread Starter
Registered User
 
Joined: Mar 2008
Posts: 56
Likes: 0
well i just got the famous FLOODING prob!! arrrgh

Towtruck on its way after calling mazda roadside service for my 04 rx8 w/22k orig on it.

I went out this morning to leave and it just keeps turning over and spiting strong gas vapors out the tail pipes
Old 04-30-2008 | 11:43 AM
  #2  
Greenblurr93's Avatar
Sotally Tober
iTrader: (1)
 
Joined: Jan 2008
Posts: 957
Likes: 1
From: The Sun
did you try and prefprm the deflood procedure first?
Old 04-30-2008 | 11:53 AM
  #3  
CyberPitz's Avatar
Huge hole is huge
 
Joined: Feb 2008
Posts: 3,191
Likes: 1
From: Joplin, MO
Originally Posted by Greenblurr93
did you try and prefprm the deflood procedure first?
I'd sure hope :P

But if you did, tough break man.
Old 04-30-2008 | 12:01 PM
  #4  
Socr8tes's Avatar
Registered Abuser
 
Joined: Jan 2005
Posts: 469
Likes: 1
Originally Posted by tvtech3
Towtruck on its way after calling mazda roadside service for my 04 rx8 w/22k orig on it.

I went out this morning to leave and it just keeps turning over and spiting strong gas vapors out the tail pipes
Did you shut it down cold? Do you have the updated starter, plugs, battery, flash?
Old 04-30-2008 | 03:37 PM
  #5  
tvtech3's Avatar
Thread Starter
Registered User
 
Joined: Mar 2008
Posts: 56
Likes: 0
Yea ive got all the latest updates/plugs etc etc and for some reason it just happened. The car only has in the low 20k,s in mileage
I rode w/the towtruck to the mazda dealer/service dept and w/in 1 hour it was ready,,, i seen the guys working on it from a distance,, they never took it in to the gargae itself but just outside the garage where they loooked to have taken some type of can of spray and squirted it into some part of the engine and it started and they frikken revved it hard and i mean hard wide open to where the cut off was kicking in and held it there for quite some time and smoke poured out the exaust,, actually i was worried about them revving it so high and for so long, but i guess they know what they are doing>>?????? i hope so. but that was it and i s im back home w/it as it didnt take long.


And yes i tried all the flooded engine tricks but no go,, it would sometime act as if it was going to start but didnt,,,,, i wonder if they just sprayed starting fluid in the air intake?
Old 04-30-2008 | 11:42 PM
  #6  
CarAndDriver's Avatar
2005 Black RX-8 GT 6M
 
Joined: Jul 2006
Posts: 6,350
Likes: 0
From: San Jose Area
Good luck. Sorry to hear!
Old 05-01-2008 | 12:09 AM
  #7  
Blazed's Avatar
Registered
 
Joined: Mar 2007
Posts: 183
Likes: 0
From: Southern California
Probably sprayed some starter fluid or engine cleaner. I hope they let your engine warm up before they started revved it that high and hard. Does anyone know if what they did is bad for our engine? Especially if the engine is not warmed up?
Old 05-01-2008 | 03:07 AM
  #8  
Bumble_Bee's Avatar
"Autobots Roll-Out..!"
 
Joined: Oct 2007
Posts: 845
Likes: 0
Originally Posted by tvtech3
Yea ive got all the latest updates/plugs etc etc and for some reason it just happened. The car only has in the low 20k,s in mileage
I rode w/the towtruck to the mazda dealer/service dept and w/in 1 hour it was ready,,, i seen the guys working on it from a distance,, they never took it in to the gargae itself but just outside the garage where they loooked to have taken some type of can of spray and squirted it into some part of the engine and it started and they frikken revved it hard and i mean hard wide open to where the cut off was kicking in and held it there for quite some time and smoke poured out the exaust,, actually i was worried about them revving it so high and for so long, but i guess they know what they are doing>>?????? i hope so. but that was it and i s im back home w/it as it didnt take long.


And yes i tried all the flooded engine tricks but no go,, it would sometime act as if it was going to start but didnt,,,,, i wonder if they just sprayed starting fluid in the air intake?

So how much did they charge you??
Old 05-01-2008 | 08:11 AM
  #9  
tvtech3's Avatar
Thread Starter
Registered User
 
Joined: Mar 2008
Posts: 56
Likes: 0
There was no charge as its still under warranty thru aug 08 and the towing was free also,,,,, and to the other poster,, no the engine was dead cold when they did the hi revs, i also wondered the same
Old 05-01-2008 | 09:20 AM
  #10  
Socr8tes's Avatar
Registered Abuser
 
Joined: Jan 2005
Posts: 469
Likes: 1
If it was cold, the ECU should have limited the revs to 7k(?) to protect the engine.
Old 05-01-2008 | 06:02 PM
  #11  
Raptor75's Avatar
Registered
 
Joined: Sep 2005
Posts: 1,364
Likes: 2
From: Chicago
More likely some type of oil to allow the seals to function. The over load of gas prevents this sealing action and therefore prevents compression, result is no start. The oil allows the seal to function again and the high revving with lots of smoke would be them burning off the oil in your combustion chamber after it starts.

Of course I don't know this for a fact but it would seem to make sense.

Originally Posted by Blazed
Probably sprayed some starter fluid or engine cleaner. I hope they let your engine warm up before they started revved it that high and hard. Does anyone know if what they did is bad for our engine? Especially if the engine is not warmed up?
Old 05-01-2008 | 11:34 PM
  #12  
CarAndDriver's Avatar
2005 Black RX-8 GT 6M
 
Joined: Jul 2006
Posts: 6,350
Likes: 0
From: San Jose Area
car is ok?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
92trbolzr
Series I Trouble Shooting
24
07-08-2020 08:59 AM
DylanForbes
RX-8 Discussion
25
10-31-2017 06:47 PM
fistofmeat
Series I Trouble Shooting
8
10-07-2016 01:15 PM
Danield97
Series I Trouble Shooting
10
10-10-2015 06:58 PM
TJSiegrist
New Member Forum
9
09-10-2015 10:29 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 12:27 AM.