3 rotor RX8 engine bay progress
#1428
Are u using rx8 front cover modified to fit 20b?
Last edited by SiNfidelity; 02-06-2014 at 08:26 AM.
#1429
#1430
angeljoelv
Thread Starter
It is funny that u mentioned it though. I had just spoken to Chris Ludwig at Ludwig motorsports about ordering a hall sensor kit, but aparently Haltech does not support it for a 3 rotor.
Last edited by angeljoelv; 02-07-2014 at 12:17 PM.
#1433
angeljoelv
Thread Starter
The motor is as tight to the firewall as it can possibly be. I did not want to modify the firewall in any way, so thats why. In the begining i did have some bumpsteer but at some point i took the crossmember out and redid everything over and since it rides like a charm. No issues at all. Its all about R&D
#1434
Thanks for your response angel, love your car by the way. Are there any draw backs to cutting the firewall besides more welding haha? Any important components behindnthe firewall I should take into consideration? Thanks
#1435
angeljoelv
Thread Starter
Its a good 5-6" that u need to cut into the car to clear the steering rack. So id say theres plenty of stuff to consider. I wouldnt know exactly because that was never my intenrion so I didnt even looked into it.
#1439
Cas
#1441
angeljoelv
Thread Starter
#1443
angeljoelv
Thread Starter
#1444
Registered
Did you tap the bottom of the tank for a sump for the 044's, create a sending unit piece, or something that would still utilize the factory straw on the OE pump assembly?
#1446
angeljoelv
Thread Starter