{ FS } 4.77 rear diff gears (pinion and ring)
#1
4.77 rear diff gears (pinion and ring)
Category: Accessories
Price: $500
Private or Vendor Listing: Private Listing
Part Fits (you may select multiples): Series I, Series II
Location (US State/Canada/Int): CA
Item Condition: Used
These gears were used in our RX-8 race car for ONE race and are in like new condition. We have since switched to even lower 5.12 gears and no longer need the 4.77 gears.
The gears alone cost close to $1000 from Mazda.
For sale for $500 shipped anywhere in the USA.
It's best to e-mail me at magnusracing@aol.com if you have questions or wish to purchase the gears. However, I will try to check this thread and my forum PMs as well.
Thanks,
John
#3
A lot of people have sent me messages asking how much these gears increase performance. Of course this is hard to quantify. One can expect a small improvement in acceleration due to the lower gear ratio. Top gear cruising rpm will of course also go up a little bit as well.
#5
Ummm... have you tried pricing these through Mazda Motorsports lately? We purchased the gears from Mazda Competition not much more than a month ago and they cost WELL over $500
#7
My comment was geared toward mm members and it was only my intent to help the part appeal to a wider audience rather than beat you up. I would rather discuss my reasoning privately than dog your thread. Good luck with the sale
#8
In any case. I'll lower my price to $450 which includes shippings.
#9
Correct me if I'm wrong but I believe that the automatic has a much higher rear end ratio. Putting in the 4.77 gears would probably be a drastic gearing change for an automatic. Sure, you would probably accelerate much faster but your cruising rpm would probably be increased so much that you probably would not want to do this on a street car. Maybe if it's a drag car or something?
#10
Correct me if I'm wrong but I believe that the automatic has a much higher rear end ratio. Putting in the 4.77 gears would probably be a drastic gearing change for an automatic. Sure, you would probably accelerate much faster but your cruising rpm would probably be increased so much that you probably would not want to do this on a street car. Maybe if it's a drag car or something?
#16
I am willing to ship to Sweden at additional cost but I have someone who contacted me first who want it shipped it Australia. If it does not go through I'll let you know.
Thread
Thread Starter
Forum
Replies
Last Post