Brakes
#1
Mu ha.. ha...
Thread Starter
Brakes
Ok, I installed new front rotors and all new pads front and rear.
Added new fluid and bled more than 1 quart through the system.
Brakes are very spongy. I have to push 3 to 4 inches instead of tapping them.
Is it possible to back out the piston too far when putting in new pads?
What is causing this spongy Feeling.
I swear there isn't any air in the system.
Do I need to get them pressure bled
Added new fluid and bled more than 1 quart through the system.
Brakes are very spongy. I have to push 3 to 4 inches instead of tapping them.
Is it possible to back out the piston too far when putting in new pads?
What is causing this spongy Feeling.
I swear there isn't any air in the system.
Do I need to get them pressure bled
#6
Momentum Keeps Me Going
Don't know about power bleeding specifically, but likely you could do it to the master cylinder as well. Follow directions above (for the car) rather than on the PB pkg.
Thread
Thread Starter
Forum
Replies
Last Post
hufflepuff
Series I Wheels, Tires, Brakes & Suspension
6
05-30-2016 10:45 AM
Road Cone
RX-8 Parts For Sale/Wanted
5
11-06-2015 01:52 PM