bee*r installation
#30
I'mma firin' mah lazor!!!
I too have a Bee*R limiter, that I had installed on an FC and my old MR2. It's a simple piece of kit that allows you to adjust (lower) your rev limit using a fuel cut rev limit. It's kind of a novelty but they are very popular in the drift circles. You can also set an RPM limit for a launch control that runs off of the 12v on your ebrake that lights up the dummy brake light on your dash.
Where it gets frustrating for me, as a forum member is when I see a thread like this, thinking I could actually get an answer as well. Instead all I see is the usual same people saying "Get a COBB/This shouldn't be done on a rotary engine/What do you need it for??" Good advice, but it doesn't have ****-from-shinola to do with what he asked.
This isn't a thread about what he need it for. This isn't a thread about how he wants a COBB. This isn't a thread about every other swingin' dick's opinion about ****. It's really frustrating when I see the regulars jump every new guy's **** for "not searching" But when threads are cluttered with useless, stupid and oftentimes WRONG information whats the point of searching?
/rant.
Where it gets frustrating for me, as a forum member is when I see a thread like this, thinking I could actually get an answer as well. Instead all I see is the usual same people saying "Get a COBB/This shouldn't be done on a rotary engine/What do you need it for??" Good advice, but it doesn't have ****-from-shinola to do with what he asked.
This isn't a thread about what he need it for. This isn't a thread about how he wants a COBB. This isn't a thread about every other swingin' dick's opinion about ****. It's really frustrating when I see the regulars jump every new guy's **** for "not searching" But when threads are cluttered with useless, stupid and oftentimes WRONG information whats the point of searching?
/rant.
#32
Tea?
iTrader: (1)
Bee-R Rev limiter fitting guide
https://www.rx8club.com/series-i-tec...-pinout-72016/
http://www.wrxtuners.com/forums/f92/...harness-33470/
http://forums.nasioc.com/forums/show....php?t=1450170
Red-Power
Black- Ground
White-Ebrake
Green- Ignition make 4 wires tap in to each coil 2Z, 2AA, 2AC, 2AD using a diode? IDK
RPM Signal- I know two wires on the coil pack to make a rpm signal? but wouldn't that conflict? Cause ignition and rpm signal uses two of the same wires?
Last edited by yokohamaboi; 11-14-2013 at 04:04 AM.
Thread
Thread Starter
Forum
Replies
Last Post
jasonrxeight
RX-8's For Sale/Wanted
2
09-30-2015 01:53 PM
Learners_Permit
Series I Interior, Audio, and Electronics
8
09-27-2015 07:38 PM
Evan Gray
Series I Trouble Shooting
0
09-26-2015 12:30 PM