http://www.pac-gate.co.jp/feed/

new equal length design no power claims.

sorry if it's a re-post.

 

I heard a header yields minimal gains. Definitely not worth the $1,000 + dollars




HMMM ????


$500 or so

 

they have a harness with a box too i wonder what that is ????

 

Damn 1000 for nothin, not the best investment, get a canzoomer and pulleys :D

 

Equal length design is awesome, I would expect gains from that. There's a huge difference between a regular header and an equal length design.

As for canzoomer and pulleys? **** that - you're a third of the way to a turbo kit. Keep saving.

 

i never said it was worth the money.
they reckon 7ps and hint at more with their exhaust. they mention doing somthing to the centre pipe for the 2 rotar problem.

the harness is probably a speed limmiter remover or something need to do a bablefish tho.

 

Pulleys are a joke. This is from somebody that has them. I am about ready to rip that stuff out of my engine. After my turbo install I got the CEL again, and the code came up pulley f-up. I had this when I first swapped out the pullies, and it eventually went away, but the pullies also make the idle rougher. Did the dyno and got 5 whp on the peak (& about 10 in the mid range) from pullies, hi-flow cat & intake total.

Canzoomer works. It has been proven many many idependent psoters on this board. Go for the Canzoomers or save up & go for the turbo.

 

Babel Fished

To evolve into isometric type, the gathering section the new design.
This corporation until recently product ratio, output 7PS and torque 3Kg rise! With simultaneous installing with sonic SR-8 exhaust efficiency substantial rise!