Small mod advice
#1
Small mod advice
Just did this simple lisence plate mod and I think the car looks much better
. I'm abit worried though that the plate is blockin to much air from comming in? I noticed the grill has very few holes in it aswell, just a few on the sides.
![Big Grin](https://www.rx8club.com/images/smilies/biggrin.gif)
![](http://i178.photobucket.com/albums/w245/kanie12/Foto-0035-1.jpg)
Last edited by kanie12; 04-11-2007 at 12:02 PM.
#2
He's as bad as Can
Unless you added a real water temp gauge to watch things I would put the plate back. Your blocking most of the airflow to the radiator & A/C condenser.
#4
Originally Posted by expo1
Unless you added a real water temp gauge to watch things I would put the plate back. Your blocking most of the airflow to the radiator & A/C condenser.
![Freak Anim](https://www.rx8club.com/images/smilies/Freak_anim.gif)
#7
I have my license plate exactly where yours is. In switzerland, license plates are much smaller than yours. I have oil and water temperature and I can say for sure that the license plate "increases" the water temp about 5-6degress celsius. I also have the strong feeling that the oil temperature is a little higher 3-4degree celsius.
I think I am going to put the license plate back to its original location. Long term reliability could be affected.
I think I am going to put the license plate back to its original location. Long term reliability could be affected.
Thread
Thread Starter
Forum
Replies
Last Post
Jst4fun
RX-8 Parts For Sale/Wanted
18
04-17-2021 07:43 AM
Michael Bryant
Series I Wheels, Tires, Brakes & Suspension
5
10-12-2015 03:07 PM