Adaptronic Select Discussion
#251
What all are you missing, still an issue? There should be a much better one now
#252
Registered
iTrader: (25)
so I’m still trying to confirm what specific connector is required for the internal 8 and 6 pin input/output slots on the Select pcb board?
think it may require the Micro JST XH 2.54mm connector, but Adaptronic never seemed to document it any where that I can find.
anyone, anyone; Bueller?
.
think it may require the Micro JST XH 2.54mm connector, but Adaptronic never seemed to document it any where that I can find.
anyone, anyone; Bueller?
.
Last edited by TeamRX8; 11-28-2021 at 12:25 AM.
#253
weeeeeeeeee
Thread Starter
iTrader: (12)
Just dropped an email to tech@adaptronic.com.au referencing this thread and forwarding your picture. If I get a response via email and they don't respond here, I'll be sure to pass the info along.
Your email has been received and created with the ticket reference ID 92706 - Subject: "Select ECU Connector Type", and will be reviewed by Adaptronic support.
All the best,
Adaptronic Support Team
All the best,
Adaptronic Support Team
The following users liked this post:
ShellDude (12-01-2021)
Thread
Thread Starter
Forum
Replies
Last Post
rickeo
Series I Trouble Shooting
7
03-10-2012 11:05 AM