TeamRX8

iTrader: (25)

The CAN references seems to have not been carried over by Haltech for the Modular ecu and otherwise are not readily available on the internet, so attaching the last info I had on them for future reference (PDF format)

Also, I have a new, unused RX8 Modular ECU listed in the FS area.
.

Knet

Been out of the game for a few years and just got back and getting my car out of hibernation. A bit annoyed to see adaptronic support just dead 😅
I have a few questions but it does seem in the long run, better to just switch ECU. I also mailed this to haltech support in hope they still reply to adaptronic questions, but if someone here can shed some light onto these things, really appreciated.


What are the 2 extra EU abs options in the last firmware update?
Also is it possible to smooth sensor readings? I have an ic7 connected to the modular via CAN and i get flickering oil and fuel pressure readings (as in super fast going from 0 to what it is supposed to be without actually being able to read it).
Lastly, i cant seem to get a wideband reading on the ic7, i have no idea what channel to use. I have the internal wideband module installed and in use.

gpvs

(Maybe it's a good place to ask before/instead of starting a new thread)

Got Adaptronic Plug and Play installed on my Series 1 RX-8. Innovate wideband AFR sensor (in slot 2).
Turned on leanout protection.

While driving, when I release acceleration pedal fast, AFR reads lean mixture. Then leanout protection kicks in.
That's all expected, but obviously this is not a desired behavior.

How do I make the protection to not protect me on deceleration and similar scenarios? Or do I correct mixture for deceleration? Please advise.

gpvs

Got Adaptronic Plug and Play installed on my Series 1 RX-8.

I've seen it has Wi-Fi, I've read somewhere it can partially operate on Wi-Fi, but I unable to connect with it. What Wi-Fi connection options are available?