Adjusting Idle Speed AP
#29
I'll snap his neck.
I can confirm ShellDude's findings. Tried raising the idle equally in all cells in all three tables, and the idle stayed exactly the same. Maybe a stupid question, but does anybody know if Cobb will take requests for making changes to the RaceTuner software? My old contact there from a couple years back apparently doesn't work there anymore, as my emails to him bounce back.
#31
do you guys have a calibration table? cous on protuner there is a calibration specification which shows unknown tables that you can set adjust
So you can name the table then set the X and Y axis and change it.
It uses the binary Image Identification, which is basically the HEX file from Mazda VCM ID CD, your Cal ID.
The tables i have are table 29,30,31,34,35,37 in 2D maps.
Hope that helps you guys using Cobb
So you can name the table then set the X and Y axis and change it.
It uses the binary Image Identification, which is basically the HEX file from Mazda VCM ID CD, your Cal ID.
The tables i have are table 29,30,31,34,35,37 in 2D maps.
Hope that helps you guys using Cobb
The following users liked this post:
GeneralBones (02-10-2020)
Thread
Thread Starter
Forum
Replies
Last Post
gwailo
New Member Forum
38
05-14-2024 06:57 AM
Touge
Canada Forum
0
09-01-2015 10:47 PM