DIY Mazdaspeed Sideskirt Install??
#1
DIY Mazdaspeed Sideskirt Install??
I am ordering the mazdaspeed sideskirts from ocmazda and im wondering is the installation simple enough to do it myself?
I currently have the stock appearance package so I dont know if I need to drill more holes, etc.
Any help is appreciated, I'd rather ship these to my door and install myself and avoid using a shop!
I currently have the stock appearance package so I dont know if I need to drill more holes, etc.
Any help is appreciated, I'd rather ship these to my door and install myself and avoid using a shop!
#3
I'm in the same boat as you. https://www.rx8club.com/showthread.p...eed+side+skirt
#7
I've been sizing this up for a while now. I would like to attempt this on my own but I have a question. With jackstands in place, would it be in the way of drilling and doing fitment tests? What do you think is the best method? Raise the whole car on 4 jackstands? Or get the car raised by wheel ramps?
#8
One side at a time. I actually found the templates to be very accurate. Line it up, measure twice, drill once (for each hole). The hardest thing for me was taking the stupid side aero flares off because the rear bolt was rusted shut.
Thread
Thread Starter
Forum
Replies
Last Post
LMURailsplitter02
New Member Forum
1
09-06-2015 10:56 PM
diy, install, installation, installing, mazda, mazdaspeed, ms, replace, rx8, rx8club, side, sideskirt, skirt, skirts, template