Installing strakes AFTER front splash guards?
#1
Registered
Thread Starter
Installing strakes AFTER front splash guards?
I'd like to install strakes, but unfortunately I already have the front splash guards. Anyone know how to do this? I'm asking because, while I'm good at following instructions, I'm not very handy—so I'm NOT the type who could "figure it out" just by looking. (In an older thread, someone mentioned it might be possible if you had small hands, which I do.) Also, would I need to replace the double-sided tape? If so, exactly what tape—brand & size—should I get?
Thanks!
Thanks!
#2
Registered
iTrader: (2)
You should be able to get around the splash guards without taking them off.
Just take the entire wheel well cover out.
Or attempt to move it around the mud flap by pulling the screw and clip from the flap and working the well cover out so you can access the side vent from inside.
Just take the entire wheel well cover out.
Or attempt to move it around the mud flap by pulling the screw and clip from the flap and working the well cover out so you can access the side vent from inside.
Thread
Thread Starter
Forum
Replies
Last Post
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM