Rear Aero Flares - Template
#1
![Post](https://www.rx8club.com/images/icons/icon1.gif)
I just bought a used rear aero flares and just realized that I am going to have to drill through the rear bumper.
Does anyone has a copy of the template and willing to email to me?
Thanks in advance.
Does anyone has a copy of the template and willing to email to me?
Thanks in advance.
#2
The Chief
iTrader: (7)
Join Date: Jun 2005
Location: Virginia Beach, VA
Posts: 827
Likes: 0
Received 0 Likes
on
0 Posts
There isn't a template if I remember correctly. After removing the rear bumper, On the inside there are 3 crosshairs stamped into the bumper for each aero flare. Drill these out and then run the drill from hole to hole to make a slot so that the plastic protrusion/slot of the aero flare will fit through. There should be metal retaining clips that will hold this in. I don't remember if a new hole had to be drilled for the screw in the wheel well, but if so, you can drill it after the flare is in place. I hope this helps.
Thread
Thread Starter
Forum
Replies
Last Post
Jst4fun
RX-8 Parts For Sale/Wanted
18
04-17-2021 07:43 AM
jasonrxeight
RX-8's For Sale/Wanted
2
09-30-2015 01:53 PM
Learners_Permit
Series I Interior, Audio, and Electronics
8
09-27-2015 07:38 PM