Notices

alittle help

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old 11-03-2005 | 08:23 AM
  #1  
kapslock16's Avatar
Thread Starter
Registered User
 
Joined: Oct 2005
Posts: 9
Likes: 0
alittle help

Ok I am trying to connect a LOC this is how I have it. I connect my speaker wire from my rear speak to it. P and V. I then grounf the LOC and connect RCA jacks to amp. Then SUb should play. OK but here is the problem. The Sub does not want to play. Anyone have any sugestions on hooking this up let me knopw please
Old 11-03-2005 | 09:19 AM
  #2  
rkostolni's Avatar
Registered
 
Joined: Aug 2004
Posts: 1,294
Likes: 0
From: Virginia/Maryland
1. Does the aftermarket amplifier have power
2. Are there any warning leds illuminated
3. Use an ohm meter and measure the resistance of the sub.
4. Connect a 9v battery to the sub and make sure it thumps.
5. Make sure the gains on the LOC and the amp are turned up.


Also, I would recommend connecting the LOC before the bose amp instead of after it. This won't make the amp not play, but it should sound better since your not putting the signal through the Bose dsp.
Old 11-03-2005 | 09:30 AM
  #3  
kapslock16's Avatar
Thread Starter
Registered User
 
Joined: Oct 2005
Posts: 9
Likes: 0
alright thx for responding. Here is my problem

My amp turns on and Yes I can hear a thump when I connect the 9v. I am using Scosche SLC4. My amp works the LED power light comes on. I ground my LOC to the battery I connected the left rear speaker and then to input A7 and A8 which are - and +. the I connect to the rca to amp. Still no sound . Also, I have stock radion no bose.
Old 11-03-2005 | 10:03 AM
  #4  
Asmoran's Avatar
Registered
 
Joined: Aug 2005
Posts: 461
Likes: 0
From: GAH!
I think that's the same LOC I was using in my last car. Kinda transluscent blue plastic? I never grounded mine and it worked fine - maybe try un-grounding it.
Old 01-21-2006 | 11:57 AM
  #5  
BomberNYC's Avatar
Registered User
 
Joined: Aug 2003
Posts: 106
Likes: 0
i have the SLC4 and one thing you might wanna check out is to make sure gain level on the LOC is up. its set to low when it comes out of the box.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
brutalbrad
RX-8 Multimedia/Photo Gallery
48
01-31-2007 03:49 PM
Fuel4theFury
RX-8 Discussion
7
10-25-2006 01:12 AM
kapslock16
Series I Interior, Audio, and Electronics
6
11-01-2005 10:28 AM
nosubstitutec4s
General Automotive
29
09-29-2004 10:11 PM
Crashunit
RX-8 Discussion
4
11-14-2003 01:18 AM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 12:28 AM.