Display not working upon reinstall (simple solution)
#1
Display not working upon reinstall (simple solution)
So after finally getting the radio back to working (it's been uninstalled for 3 months), the display wasn't showing anything. all the control worked, just no display. I checked the fuses, researched for a few hours until I finally went through the official removal tutorial and noticed there was a plug I didn't see.....
Anyways, the plug is on the left hand side. I popped the headunit out 2 inches, plugged the cord back in and wired everything else without installing it fully and it works.
link to the plug I missed:
WhatsMyIP.org | iPod RX-8 | Page 7
Just wanted to add this in case anyone is searching and also missed this.
Anyways, the plug is on the left hand side. I popped the headunit out 2 inches, plugged the cord back in and wired everything else without installing it fully and it works.
link to the plug I missed:
WhatsMyIP.org | iPod RX-8 | Page 7
Just wanted to add this in case anyone is searching and also missed this.
Last edited by mxer657; 04-11-2013 at 06:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post
MolecularConcept
New Member Forum
15
08-05-2015 04:43 PM