Good ground in trunk?
#1
Drive Like you stole it
Thread Starter
Join Date: Jul 2006
Location: Knoxville, TN
Posts: 406
Likes: 0
Received 0 Likes
on
0 Posts
Good ground in trunk?
Before i proceed... Yes, i did read the sticky about the grounds...
My question is where are some good places to ground in OUR cars in the trunk?
What is the best route to run 0 awg wire to the trunk without interference
My question is where are some good places to ground in OUR cars in the trunk?
What is the best route to run 0 awg wire to the trunk without interference
#3
Deals on wheels
abbid - we've already went over this in his other thread, he knows it's overkill but it's not really going to do any harm.
i would run it along the passenger side door - assuming you can get it to fit in there, there isn't any other wires in there.
and as for grounds.. some people claim to have luck with some random spots, but back to the battery is defiantly the only way to go in my head for this car.
i would run it along the passenger side door - assuming you can get it to fit in there, there isn't any other wires in there.
and as for grounds.. some people claim to have luck with some random spots, but back to the battery is defiantly the only way to go in my head for this car.
#4
Administrator
iTrader: (7)
I ran 6 guage along the passenger side door and I BARELY got the damn thing to close. It's going to be a tight fit...
#5
Drive Like you stole it
Thread Starter
Join Date: Jul 2006
Location: Knoxville, TN
Posts: 406
Likes: 0
Received 0 Likes
on
0 Posts
yYeah, I was able to get the kicker amp kit for the same amount of $$ as a regular 4 gauge. Right now i have the power running up thru the center console. I dont know if I can get two of the 0awg wires thru there... I know it will not go along the pass side...
#6
Deals on wheels
Originally Posted by Jedi54
I ran 6 guage along the passenger side door and I BARELY got the damn thing to close. It's going to be a tight fit...
I ran two 4 AWG (power and ground) through the driver side, with all the regular wires that are in there. Granted i had to cut out those plastic tab things, but it all fits..
have you tried the door thing without those plastic holder tabs? maybe you could do one in the center and one in the door, or down each side of the center.
(this is why you don't use 0 AWG unless you are going from your 4 batteries in your trunk to your Dist. block less than a foot away)
#7
Administrator
iTrader: (7)
I ran two 6guage in there and it was one hell of a tight fit to get the thing to clip back into place.
#9
resU deretsigeR
Join Date: Jan 2006
Location: Jacksonville, FL
Posts: 743
Likes: 0
Received 0 Likes
on
0 Posts
My 2 gauge JL power wire fit easily along the passenger side under the white clips. I think forbidden ran (2) 0 gauge down the passenger side.
I currently have my ground at one of the bottom mounting bolts of the back seat w/ no problems, however, I still have small amps.
I currently have my ground at one of the bottom mounting bolts of the back seat w/ no problems, however, I still have small amps.
Last edited by jstkilntim; 03-29-2007 at 08:12 PM.
#10
Drive Like you stole it
Thread Starter
Join Date: Jul 2006
Location: Knoxville, TN
Posts: 406
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by abbid
for the record, 0gauge will flow 8000 watts peak and over 3k rms..
talk about OVERkill.
Thread
Thread Starter
Forum
Replies
Last Post
BigMikeATL
RX-8's For Sale/Wanted
12
05-26-2016 12:31 AM
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM