Installing PIAA fog lights
03-21-2005 | 08:53 PM
#1
Thread Starter
Registered User
Joined: Nov 2004
Posts: 93
Likes: 0
From: Houston, TX
Installing PIAA fog lights
Hey everyone,
About to install a pair of PIAA fog lights and the instructions says I need to tap into a "power source to connect the switch power wire to." Anyone suggestions as to where I should tap this too? I believe its only the power leading to the switch but not sure if the lights will "see" this source and the relay kicks them on... not sure on that. but I'm assuming I need a 12V source.
Any help?? thanks!
Ed
About to install a pair of PIAA fog lights and the instructions says I need to tap into a "power source to connect the switch power wire to." Anyone suggestions as to where I should tap this too? I believe its only the power leading to the switch but not sure if the lights will "see" this source and the relay kicks them on... not sure on that. but I'm assuming I need a 12V source.
Any help?? thanks!
Ed
Thread
Thread Starter
Forum
Replies
Last Post
akagc
RX-8's For Sale/Wanted
7
08-11-2015 08:07 PM
SayDfuse
Series I Exterior Appearance and Body Kits
3
08-03-2015 11:41 PM
