JL CleanSweep: signal sense not working
#1
JL CleanSweep: signal sense not working
I just installed a cleansweep this weekend and I can't get the signal sense to work.
I only need the cleansweep for one set of RCA's. I have the rear left and right bose amp inputs tapped to send a signal to the cleansweep.
I am getting a low voltage signal from the cleansweep to the amp.
I'm wondering if anyone is using the cleansweep in their 8 with a bose amp, and how they wired everything up.
I would like to eventually remove the bose amp from the car, and run my system from only the inputs that are in the trunk for the bose amp.
I only need the cleansweep for one set of RCA's. I have the rear left and right bose amp inputs tapped to send a signal to the cleansweep.
I am getting a low voltage signal from the cleansweep to the amp.
I'm wondering if anyone is using the cleansweep in their 8 with a bose amp, and how they wired everything up.
I would like to eventually remove the bose amp from the car, and run my system from only the inputs that are in the trunk for the bose amp.
Thread
Thread Starter
Forum
Replies
Last Post
CARBONRX-8
RX-8 Parts For Sale/Wanted
1
08-23-2015 09:52 PM