20B renesis pics!!!!!!!
#1
3-rotor renesis pics!!!!!!!
Here it is!!!!
Engine is running in a drift FD in the UK... thought a 3rotor with side exhaust ports wasn't possible!
The vechicle that's it all in.
Built by----> http://www.mazdarotary.co.uk/
Engine is running in a drift FD in the UK... thought a 3rotor with side exhaust ports wasn't possible!
The vechicle that's it all in.
Built by----> http://www.mazdarotary.co.uk/
Last edited by crispeed; 03-20-2008 at 04:48 AM.
The following users liked this post:
Harrod19 (01-11-2023)
#6
Registered
Cool looking. It's based on the lower power 4 port engine. I'm not so concerned over whether it actually runs as I am with how much power each rotor makes in relation to each other. I just can't believe that the middle rotor breathes as well as the others due to both of it's exhaust ports being siamesed. You really do need to see those up close to fully appreciate how terrible flow through them is.
#9
#14
If it's a 20b rene, why does it have 4 exhaust tubes? Isn't it a 2.6 that is two rene's put together??? Even though it just has 3 intake tubes???
edit: NM, I just looked closely again and saw the rotor housings.... <---nub
edit: NM, I just looked closely again and saw the rotor housings.... <---nub
#18
Registered User
Join Date: Oct 2005
Location: Toronto, Canada
Posts: 2,047
Likes: 0
Received 0 Likes
on
0 Posts
nice to see it done. I predict it could make about 350hp. I don't think the middle rotor of this setup could handle a 6-port version, the exhaust side would be really restricted.
________
Live Sex
________
Live Sex
Last edited by Renesis_8; 09-11-2011 at 02:38 PM.
#20
I don't buy Kool-Aid
#21
I don't buy Kool-Aid
Yup 26Bs have 4 rotors
#22
A quote from the creator!
'Since I have actually built the engine and tuned it i can say that it is very good and I have not driven an N/A engine like it.
This is what the RX8 should have in it.
It has lots of low down torque ,but still wants more and more revs.
Zero overlap of the inlet and exhaust ports helps with exhaust evacuation.
The car has not been on a dyno yet,but I can say that it pulls harder than a modified FD RX7 that is still on stock twin turbo's running around 330hp.
Regards'
Carl
__________________
Hayward Rotary
www.mazdarotary.co.uk
'Since I have actually built the engine and tuned it i can say that it is very good and I have not driven an N/A engine like it.
This is what the RX8 should have in it.
It has lots of low down torque ,but still wants more and more revs.
Zero overlap of the inlet and exhaust ports helps with exhaust evacuation.
The car has not been on a dyno yet,but I can say that it pulls harder than a modified FD RX7 that is still on stock twin turbo's running around 330hp.
Regards'
Carl
__________________
Hayward Rotary
www.mazdarotary.co.uk
The following users liked this post:
Harrod19 (01-11-2023)