9 psi, 330whp?
maybe .....
11-21-2008, 10:28 AM
#30
Registered
Thread Starter
Join Date: Jan 2007
Location: NJ
Posts: 1,401
Likes: 0
Received 0 Likes
on
0 Posts
don't worry, wait for BHR turbo kit, because i believe it's good. the same set up as greddy, but it has bigger turbo, and believe me, it always put a smile on your face.
steven
11-21-2008, 10:39 AM
#32
http://ppo2performance.com/docs/?p=146
EVIL...
11-21-2008, 01:07 PM
#36
Yeah, Brettus, I would be careful pushing the GReddy snail too far. Above 12psi or so it turns into a hairdryer and starts blowing some seriously hot air as it falls off it's efficiency island.
A post intercooler, pre-throttle body IAT sensor is a good idea along with water/meth injection with at 49% meth or alky to help cool the charge and reduce detonation chances. With that combo I bet you get to 310 or so, depending on the strength of your motor.
A post intercooler, pre-throttle body IAT sensor is a good idea along with water/meth injection with at 49% meth or alky to help cool the charge and reduce detonation chances. With that combo I bet you get to 310 or so, depending on the strength of your motor.
11-21-2008, 01:27 PM
#40
If you want get fancy (and serious) THIS is probably the best IAT meter on the market. Two sensors, one for pre intercooler and for post, displays either sensor or shows you the temp difference (intercooler efficiency). Real slick, but pricey.
I plan on getting it after the holidays. I've heard it's response time is scary fast and it's dead accurate.
Otherwise PLX, AutoMeter, and most other top gauge manufactures have an IAT sensor or gauge.
I plan on getting it after the holidays. I've heard it's response time is scary fast and it's dead accurate.
Otherwise PLX, AutoMeter, and most other top gauge manufactures have an IAT sensor or gauge.
11-21-2008, 01:31 PM
#41
Yeah - if you already have autometer - you can get theirs; order from Ray since his prices are good w/ Autometer.
Unless you wanna go baller style like Chicken said.... then again for that kind of jack + water meth jack; you can just get a better turbo and not worry about it.
Unless you wanna go baller style like Chicken said.... then again for that kind of jack + water meth jack; you can just get a better turbo and not worry about it.
11-21-2008, 01:38 PM
#42
Water/meth kit- $400 bucks, IAT gauge- $200 or more. Well, he's still at only $600+, Jeff's upgrade is $1800+ and as he said, long wait times as he is only one man.
Not to mention having the water/meth kit and IAT gauge is a good idea with the upgrade as well, so...I still say go for it.
Not to mention having the water/meth kit and IAT gauge is a good idea with the upgrade as well, so...I still say go for it.
11-21-2008, 01:59 PM
#50
We actually do have one of the worlds top rotary engine builders here - he built the engine for the 6second PR drag RX8 and more recently a 3 rotor renesis motor . Could be a good time to get that 3 rotor ?
not the same money - ours is worth even less than theirs
not the same money - ours is worth even less than theirs